Linksys DMP100 manual IC Class B Statement Canada, Règlement de la classe B d’Industrie Canada

Wireless Home Audio Regulatory Information

IC Class B Statement (Canada)

This class B digital device complies with Industry Canada ICES-003 and RSS-210 rules.

Operation is subject to the following two conditions

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device

This device has been designed to operate with an antenna having a maximum gain of 3.5dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.

Règlement de la classe B d’Industrie Canada

Cet appareil numérique de la classe B est conforme à la norme NMB-003 et RSS-210 d’industrie.

L’opération est sujette aux deux conditions suivantes :

1.Ceci le dispositif peut ne pas causer l’interférence et

2.Ceci le dispositif doit accepter n’importe quelle interférence, y compris l’interférence qui peut causer fonctionnement peu désiré du dispositif.

Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain maximum du dBi 3.5 L’antenne ayant un gain plus élevé est strictement interdite par règlements d’industrie Canada. L’impédance exigée d’antenne est de 50 ohms.

Industry Canada Interference Statement

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co- channel mobile satellite systems;

The maximum antenna gain 3.5dBi permitted (for devices in the band 5250 - 5350 MHz and 5470 - 5725 MHz ) to comply with the e.i.r.p. limit ; and the maximum antenna gain 3dBi permitted (for devices in the band 5725-5825 MHz) to comply with the e.i.r.p. limits specified for point- to-point and non point-to-point operation as appropriate, as stated in section A9.2(3).

The DMP100 Player has disabled the 5600-5650M band by S/W to avoid 5600-5650M band for IC certification.

WARNING: In addition, users should also be cautioned to take note that high-power radars are allocated as primary users (meaning they have priority) of the bands 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN device.

CE – Marking

CE marking on this product represents the product is in compliance with all directives that are applicable to it.

EU Declaration of conformity (DOC)

This product complies with the essential requirements of the EMC Directive 2004/108/EC, the Low Voltage Directive 2006/95/EC and the R&TTE Directive 1999/5/EC. For more detail, Please see the DoC.

NOTE: For all Cisco-Linksys products, the Declaration of Conformity (DoC) is available in one or more of the following options:

•• A PDF file is included on the product’s CD.

•• A printed copy is included with the product.

•• A PDF file is available on the product’s webpage. Please visit www.linksysbycisco.com/international and select your country region. Then select your product model.

R&TTE Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. Compliance Information for 2.4-GHz and 5-GHz Wireless Products Relevant to the EU and Other Countries Following the EU Directive1999/5/ EC (R&TTE Directive).The following standards were applied during the assessment of the product against the requirements of the R&TTE Directive:

•• Radio: EN 300 328 (2.4GHz), EN 301 893 (5.0GHz)

•• EMC: EN 301 489-1, EN 301 489-17

•• Safety & Health: EN 60065 and either EN 50385 or EN 50371 if applicable

Player/Wireless-N Music Extender 40