WAN Settings
1.Device Operating Mode: you choose either “Router” or “Bridge”, depending on your operation.
2.You will check either “Obtain WAN configuration dynamically” or “Specify fixed WAN configuration”.
When you choose “Obtain WAN configuration dynamically”, the information is detected automatically through DHCP.
If you choose “Specify fixed WAN configuration”, you are required to enter the IP address, IP of the Sub mask, IP of the Gateway, and IP of the DNS Server, if applicable.
3. Multicast Limits:
Broadcast Limit: the value specifies the maximum limit on the percentage of broadcast packets, which will be bridged to the destination interface (as a percentage of the source side bandwidth)
8