K7000G Manual 11/30/01 5:04 PM Page 4
ASSEMBLY INSTRUCTIONS
Tools required. adjustable pliers.
OPERATING INSTRUCTIONS
Step 1 Tilt machine back- wards slightly (caution: oil may leak if tilted too far). Attach the front guard to the frame. Align holes, insert bolt and tighten with lock nut.
3
Step 2 Attach the handle to the frame of the pressure washer. Align holes, insert bolt, and tighten with knob.
Step 3 Attach high pressure hose to trigger gun.
Step 1 Connect the high pressure hose | Step 2 Connect garden hose to unit’s |
to the unit’s high pressure outlet. | water inlet. |
4
Step 3 Connect garden hose to | Step 4 Trigger the gun to eliminate trapped air, |
the cold water source and turn water | wait for a steady flow of water to emerge from the |
on completely. | spray nozzle. |
Step 4 Attach the triple jet nozzle to the spray wand.
Step 6 Check oil level. Oil level should be to the oil filler neck. Be sure the machine is level when checking the oil level. (Refer to the engine’s operating manual for seasonal grades.)
Step 5 Attach the spray wand to the trigger gun.
Step 7 Fill gas tank with unleaded gasoline. Do not use leaded gasoline.
Important! Do not run the engine with a high or low oil level as this can cause
engine damage. If you have further questions regarding the engine, please refer to the engine’s operating manual included with the unit.
Step 5 Slide the throttle control to the fast | Step 6 Pull the starter handle. If |
position. Move the choke lever to the “CHOKE” | the engine fails to start after 3 pulls |
position (only if the engine is cool). After starting, | squeeze the trigger gun to release |
move the choke to “RUN”. Turn fuel valve to “ON”. | pressure, and repeat step 6. |