Karcher 397 m plus, darcher manual End Of Operation, We recommend the following cleaning method

Page 11

We recommend the following cleaning method:

Step 1:

Remove loose dirt by washing over the surface to be cleaned with the high pressure jet.

Step 2:

Spray on the detergent and leave for 1-4 minutes, so assisting the easy removal of fine dirt and associated greasy adhesions.

Step 3:

Finally, spray off the loosened dirt with the high pressure spray.

4.3End Of Operation

ALWAYS REMEMBER TO RINSE YOUR PRESSURE WASHER AFTER USING DETERGENT BY HANGING THE DETERGENT SUCTION TUBE IN A CONTAINER WITH CLEAN WATER AND RUN THE PUMP FOR APPROXIMATELY ONE MINUTE IN LOW PRESSURE SETTING.

In the event of a break of 5 minutes in the operation of your Karcher Pressure Washer, always switch off the pump to avoid damage due to overheating.

Switch off the pressure washer by the Power Switch (No. 2) and unplug the Mains Electric Lead (No. 9) from the socket

Close the water inlet (tap) and disconnect the hosepipe

Release the trigger to remove all pressure from the machine and then secure the trigger with the Safety Ratchet to prevent accidental opening.

11

Image 11
Contents Plus Thank YOU for Purchasing a Karcher Pressure Washer Operating Your Pressure Washer IndexApplications Safety Assurance Safety InstructionsGetting Started ContentsElectrical Connection Water ConnectionRecommended Detergents DetergentOperating Your Pressure Washer Low Pressure Operation High Pressure OperationEnd Of Operation We recommend the following cleaning methodWater Important Care and MaintenancePage Rotary Wash Brush AccessoriesPlus Spare PartsProblem Possible Cause Correction Problem ChecklistHelp-Line Water Connection Technical DataAssembly Harmonised standards applied