Assembly Instructions and Parts List | PW132000AV |
Power Cord
1.Plug the power cord into a ground- ed 120V outlet and press the reset button as shown in figure 3.
2.THIS MUST BE DONE EACH TIME THE UNIT IS PLUGGED IN AN OUTLET.
Reset
Figure 3 - Grounded plug/reset button
! IMPORTANT !
This pressure washer is equipped with a microswitch sensitive to water flow. This Instant Start/Stop switch (ISS) senses water flow in the pump. When the trig- ger is released, water stops flowing through the pump. The ISS then auto- matically turns the motor off to protect pump from overheating.
OPERATION
1.Pull trigger on gun and hold.
2.Turn the “ON/OFF” switch to “ON”.
3.Release trigger. The pressure washer motor will stop running.
4.To spray again, pull trigger and motor and pump will restart.
Note: Occasionally the motor may run for a short time to bring fresh, cool water into the pump even if trigger is released. This is part of normal opera- tion and will not damage the unit.
Always turn the
!CAUTION “ON/OFF” switch to “OFF,” then trigger gun to release hose pressure before unplugging power cord.
Risk of equipment dam-
!CAUTION age. Always make sure the “ON/OFF” switch on the unit is “OFF” and unit is unplugged prior to storage.
Risk of Injection.
!WARNING Unit will start spraying when trigger is squeezed if on/off switch is in “ON” position. Always point gun in safe direction.
Call
www.chpower.com
2