Pentair Pump important safety instructions Clamp

Page 4
Figure 3.

WARNING

THIS FILTER OPERATES UNDER HIGH PRESSURE. WHEN ANY PART OF THE CIRCULATING SYSTEM (e.g., LOCK RING, PUMP, FILTER, VALVES, ETC.) IS SERVICED, AIR CAN ENTER THE SYSTEM AND BECOME PRESSURIZED. PRESSURIZED AIR CAN CAUSE THE LID TO BLOW OFF WHICH CAN RESULT IN SEVERE INJURY, DEATH, OR PROPERTY DAMAGE. TO AVOID THIS POTENTIAL HAZARD, FOLLOW THESE INSTRUCTIONS.

10.

Open the High Flow™ manual air relief valve on top of the filter.

Clamp

11.

Stand clear of the filter. Start the pump.

Lid

12.

Bleed air from the filter until a steady stream of water comes out.

 

 

Close the High Flow™ manual air relief valve.

 

B. Winterizing.

 

1.

If the air temperature drops below 35° F. the water in the pump can

 

 

freeze and cause damage. Freeze damage is not warrantable.

Volute

 

 

2.To prevent freeze damage follow the procedures listed below.

a. Shut off electrical power for the pump at the house circuit breaker.

b. Drain the water out of the pump case by removing the two thumb- twist drain plugs from the case. Store the plugs in the pump basket.

c. Cover the motor to protect it from severe rain, snow and ice.

d. Do not wrap the motor in plastic. It will cause condensation and rust on the inside of the motor. C. Care of Electric Motor.

1. Protect from heat.

a. Shade the motor from the sun.

b. Any enclosure must be well ventilated to prevent overheating. c. Provide ample cross ventilation.

2. Protect against dirt.

a. Protect from any foreign matter or splashing water. b. Do not store (or spill) pool chemicals near the motor.

c. Avoid sweeping or stirring up dust near the motor while it is operating. d. If a motor has been damaged by dirt it voids the motor warranty.

3. Protect against moisture.

a. Protect from splashing pool water. b. Protect from the weather.

c. Protect from lawn sprinklers.

d. If a motor has become wet - let it dry before operating. Do not allow the pump to operate if it has been flooded.

e. If a motor has been damaged by water it voids the motor warranty.

NOTE

DO NOT wrap motor with plastic or other air tight materials. The motor may be covered during a storm, for winter storage, etc., but never when operating, or expecting operation.

NOTE

When replacing the motor, be certain that the motor support is correctly positioned to support the size of motor being installed.

P/N 071109

4

Rev. D 6-5-01

Image 4
Contents WhisperFlo Chart Section I. General InformationSection II. Maintenance Clamp Section III. Service Read all servicing instructions before working on the pumpSection IV. Restart Instructions Section V. Troubleshooting Section VI. Technical Data Replacement PartsSingle Speed Models Pentair Pool Products