SAFETY & WARNING INSTRUCTIONS
OPERATING INSTRUCTIONS
continued
Storing Your Pressure Washer
Ground Fault Circuit
WARNING
Do not use pressure that exceeds the operating pressure of any of the parts (hoses, fittings, etc.) in the pressurized system. Ensure that all equipment and accessories are rated to withstand the maximum working pressure of the unit.
WARNING
Explosion hazard.
•NEVER spray flammable liquids of use pressure washer in areas containing combustible dust, liquids or vapors.
•NEVER operate this machine in a closed building or in or near an explosive environment.
WARNING
Do not spray electrical apparatus or wiring.
•NEVER disconnect the high pressure discharge hose from the machine while the system is pressurized. To depressurize the machine, turn the power and water supply off, then press the gun trigger
•NEVER permanently engage the trigger mechanism on the gun.
•NEVER operate the machine without all the components properly connected to the unit (handle, gun/lance assembly, nozzle, etc.).
WARNING
Equipment damage.
•ALWAYS turn water supply "ON" before turning the pressure washer "ON". Running pump dry causes serious damage.
•Do not operate the pressure washer with the inlet water screen removed. Keep screen clear of debris and sediment.
•NEVER operate pressure washer with broken or missing parts. Check equipment regularly and repair or replace worn or damaged parts immediately.
•Use only the nozzle supplied with this machine.
•Never leave the lance unattended while the machine is running.
•Never attempt to alter factory settings. Altering factory settings could damage the unit and will void the warranty.
•Always hold gun and lance firmly when starting and operating the machine.
•NEVER allow the unit to run with the trigger released (OFF) for more than one minute. Resulting heat buildup will damage pump.
•NEVER store the pressure washer outdoors or where it could freeze. The pump will be seriously damaged.
•Release trigger when changing from high to low pressure modes. Failure to do so could result to damage to the nozzle.
•This unit must always be used in the horizontal position.
CAUTION
Keep hose away from sharp objects. Bursting hose may cause injury. Examine hoses regularly and replace if damaged. Do not attempt to mend a damaged hose.
EXTENSION CORDS
DANGER
If using an extension cord, use only grounded, three wire extension cords that are in good condition. Use only extension cords that are intended for outdoor use. These extension cords are identified by a marking "Acceptable for use with outdoor appliances; store indoors while not in use." use only extension cords having an electrical rating not less than the product. Do not use damages extension cords. Examine extension cord before using and replace if damaged. Do not abuse extension cord and do not pull on the cord to disconnect. Keep cord away from heat and sharp edges. Always disconnect from the receptacle before disconnecting the product from the extension cord.
Note: Do not use 16 or 18 AWG extension cords on this product.
DANGER
Failure to follow these instructions can result in serious injury, including death.
WARNING
To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch the plug with wet hands.
Extension Cord | Allowable Length | ||
|
| ||
25' | 50' | ||
| |||
14 AWG | YES | NO | |
|
|
| |
12 AWG | YES | YES | |
|
|
| |
When you have finished using your pressure washer, follow these steps for safe storage:
1.Turn the pressure washer to the "Off" position.
2.Turn off the water supply.
3.Before disconnecting the high pressure hose connection, point the trigger gun in a safe direction away from you and discharge the high pressure water. Disconnect the high pressure hose from the pressure washer.
4.Disconnect garden hose from pressure washer.
5.Remove excess water from the pump by tipping the unit on both sides to drain any remaining water from the water intake and outlet fittings.
6.Drain detergent applicator bottle and flush with clean water.
7.Wipe away any remaining water on all parts and fittings.
8.Engage the trigger gun safety lock.
9.Store the unit and accessories in a room above 32°F.
Winterizing & Long Term Storage
1.Disconnect all water connections.
2.Turn the pressure washer on for a few seconds, until any remaining water in the pump exits.
3.Turn the unit off immediately.
4.Store the pressure washer, parts and accessories in an area with a temperature above 32°F.
Motor Thermostat
Important: This pressure washer is equipped with a motor thermostat. The motor will stop if it is overheating. Wait
Interrupter (GFCI)
This unit is equipped with a Ground Fault Circuit Interrupter (GFCI) built into the plug. This device provides additional protection from the risk of electrical shock. When connecting the GFCI to the electrical outlet, the indicator should appear red. If the indicator is not red, depress the RESET button on the GFCI until the indicator appears red.
Cleaning Tips
Wood Decks: Rinse deck and surrounding area with fresh water. If using detergent, fill the detergent applicator bottle and apply to the area being cleaned. For optimal results, reduce your work area to small sections and clean each section one at a time. Allow the detergent to rest on the surface for a few minutes and then rinse at high pressure. Do not let the detergent dry on the deck. Always clean from left to right and top to bottom for best results. Rinse at high pressure using the lance keeping the tip of the spray nozzle
Cars, Boats, & Motorcycles: Wet down area to be cleaned before applying detergent with clean water. Fill the detergent applicator bottle and apply to the area being cleaned. To achieve best results, clean one side at a time. Allow the detergent to rest on the surface for a few minutes but do not let it dry. Rinse at high pressure using the fan jet in a sweeping motion keeping the tip of the spray nozzle at least
2 | 7 |