SmartPool Inc S421 operation manual Operation, Winterization, Collector Repair

OPERATION & MAINTENANCE

Operation

1.The collectors should feel cool to the touch when the sun is shining on them and water is passing through. This means that the heat is being transferred to the water.

2.The water returning to your pool will be a few degrees (3-5 degrees F/2-3 degrees C)) warmer than the pool itself. This is the most efficient way to heat a large body of water like a pool. Keep circulating the water, which adds a few degrees each pass.

3.Circulate water though the solar collectors at least 6 hours per day during the daylight hours on sunny days. If you circulate your water through them at night, or when it’s overcast or on chilly days, you will cool your pool water rather than heat it. If you need to run your pump at night, divert the water directly back to the pool and bypass the solar system.

Winterization

YOUR SOLAR SYSTEM MUST BE DRAINED FOR WINTERIZATION! FREEZE DAMAGE IS NOT COVERED UNDER WARRANTY! YOU MUST DRAIN YOUR SOLAR COLLECTORS JUST LIKE

YOU DRAIN THE REST OF YOUR POOL EQUIPMENT!

Remove the white end cap at the top of the solar system. Remove the white end cap at the bottom and be sure ALL the water is drained out of the system. Replace end caps and blow pressurized air through the system. After blowing them out, remove and store the bottom end cap for use again in the spring when you start up again. You can leave the collectors in place (as long as they are completely drained) and they will withstand even the harshest winters. SmartPool recommends that you store your collectors inside in a warm dry place.

Collector Repair

YourIF A COLLECTORsolar collectorsDEVELOPSare warrantedA LEAKagainst defects in materials and workmanship (see warranty for details and limitations). If a leak develops for any other reason, you may use the repair method shown. Collectors are not warranted against freeze damage.

ThisSOLARmethodCOLLECTORallows for REPAIRan easy and permanent, on-site repair of a collector by isolating the leading riser tube. Referring to the figure at the right, locate the tube to be isolated. (End tube has been shown for clarity). Using a sharp utility knife, very carefully cut away approximately 1" (25 mm) of the tube at both headers. Drive a #10 sheet metal screw, preferably stainless, into the hole3/4" (19in themm)header.long. The screw must be between 1/2" (12.7 mm) and

If the screw strips out, or if the repair leaks,

useDO NOa #12T OVERTIGHTEN!screw. This repair method will not void the collector warranty.

With proper care and winterization, you will enjoy your solar collectors for many years.

6