Zenoah G2000T Explanation of Symbols on the Machine, Position Fuel cap, Position Oil cap

G2000T

2. Explanation of Symbols on the Machine

WARNING

For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to make any mistake.

The port to refuel “MIX GASOLINE”

Position: Fuel cap

G

B

The port to top up chain oil

Position: Oil cap

Setting the switch to the “O” position, the engine stops immediately. Position: Front at the top of the rear handle

Starting the engine. If you turn the choke knob to the point of the arrow, you can set the starting mode as follows:

Position: Right side of the rear handle

The screw under the “H” stamp is The High-speed adjustment screw.

The screw under the “L” stamp is The Slow-speed adjustment screw.

The screw at the left of the “T” stamp is the Idle adjustment screw. Position: Left side of the rear handle

Shows the directions that the chain brake is released (white arrow) and activated (black arrow).

Position: Front of the chain cover

If you turn the rod by screwdriver follow the arrow to the "MAX" position, the chain oil flow more, and if you turn to the "MIN" position, less. Position: Top of the power unit

GB-7