Zenoah EB4401 manual Adjusting Idle Speed, Stopping Engine

Page 13

Operation

the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up.

NOTE

•When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope.

■ADJUSTING IDLE SPEED

•The idling speed is set for 2000 rpm at the factory. If it is necessary to adjust the idle speed, use the adjustment screw on the top side of carburetor.

■STOPPING ENGINE

•Move the throttle lever to the idling position and press the stop switch (red button) until the engine comes to a complete stop.

Stop Switch

13 

Image 13

Contents EB4401 Safety First Contents Operator Safety PrecautionsUSE of Blower Working Condition FuelAvoid Chances of Damage Avoid Noise Problem 7  USE Jaso FC or ISO EGC Grade 501 OIL Symbols on the machineAssembly Parts Location & SpecificationsModel EB4401 Blower TubesFuel HOW to MIX FuelRecommended Mixing Ratio Gasoline 50OIL For Your Engine LIFE, Avoid Fueling the UnitControl ARM OperationStarting Engine Important Stopping Engine Adjusting Idle SpeedAIR Cleaner MaintenanceReplacement Plug is a Champion RJ6C Fuel FilterSpark Arrester MufflerAIR Inlet NET Important Storage DisposalShoulder Strap Before Storing the BlowerParts List Parts List EB4401 EB4401  20   21   22   23  Manufacturer’s warranty coverage Limited Warranty Garantie limitée Page Zenoah AMERICA, INC