Zenoah BT251 manual 12 , Recommended Mixing Ratio Gasoline 50OIL, HOW to MIX Fuel

Page 12

7. Fuel

WARNING

Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m (10ft) away from the fueling point before starting the engine.

The ZENOAH engines are lubricated by oil specially formulated for air-cooled 2- cycle gasoline engine use. If ZENOAH oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE)

Do not use BIA or TCW (2-stroke water- cooling type) mixed oil.

12

RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1

(when using ZENOAH genuine oil)

50:1 MIXING CHART

GASOLINE gal. 1 2 3 4 5

2-CYCLE OIL fl.oz 2.6 5.2 7.8 10.4 13

GASOLINE

liter

1

2

3

4

5

 

 

 

 

 

 

 

2-CYCLE OIL

ml

20

40

60

80

100

 

 

 

 

 

 

 

Exhaust emission are controlled by the fundamental engine parameters and components(eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

These engines are certified to operate on unleaded gasoline.

M ake sure to use gasoline with a minimum octane number of 89 RON (USA/Canada: 87AL)

If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may rise and an engine problem such as piston seizing may consequently occur.

Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.

HOW TO MIX FUEL

IMPORTANT

Pay attention to agitation.

1.Measure out the quantities of gasoline and oil to be mixed.

2.Put some of the gasoline into a clean, approved fuel container.

3.Pour in all of the oil and agitate well.

4.Pour In the rest of gasoline and agitate

Image 12
Contents BT251 Safety First ContentsSpecifications Parts locationSymbols on the machine For safe operation Working ConditionWorking Circumstance Working Plan Before Starting the Engine Starting the EngineUsing the Product Maintenance If Someone ComesHandling Fuel Transportation10  Set up SE1 SE2 SE3 Installing Handle SE1Installing Debris Guard SE2 Installing Cutting Head SE3HOW to MIX Fuel Fuel12  Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, Avoid13  Operation OP1 OP2 OP3 OP414  Starting EngineAdjusting Idling Speed OP5 OP5 OP6 Stopping EngineLine Head Usage Trimming Grass and WeedsAdjusting the Line Length 16 Maintenance Refilling Trimming Line17  18  19  MA5 20 Muffler Spark ArresterProcedures to be Performed After Every 100 Hours of USE MA6 MA721  Troubleshooting guide StorageDisposal Check Probable Causes ActionLimited warranty 23 Zenoah