RedMax CV225 manual Additional Information

Page 13

Starting a Warm Engine

1.Slide ignition switch to START position.

2.Move the choke lever to the Open (Run) position.

3.If there is no fuel in the clear return line, push primer bulb 3-4 times or until fuel is visible in the line.

4.Pull starter rope using short pulls, 1/2 to 2/3 of the rope length.

5.If engine fails to start in 4 pulls, use “First Time” starting procedure on page 14.

6.With engine running, and both hands on the handles, squeeze throttle trigger gradually to increase the engine speed and engage the tines.

WARNING DANGER

AVOID ACCIDENTAL BLADE ENGAGEMENT.

DO NOT SQUEEZE THE THROTTLE TRIGGER WHEN

STARTING. MAINTAIN PROPER IDLE

SPEED ADJUSTMENT (220 - 2300 RPM).

Additional Information

How to Stop the Engine

Simply push the o/I switch into the I “stop”

position. This will stop the engine instantly. If it

should ever fail to do so, just pull out the choke

button. The engine will stop at once.

About the Choke

The choke controls the amount of air drawn into the

engine. Your Tiller/Cultivator will run only if the

choke is open — that is, if the choke is pushed in.

A Special Feature (with the idle set properly and

the engine running)

Even when the engine is running, the tines won’t turn unless you press the throttle lever on the handlebars. And, when you release the throttle lever, the tines will stop.

A Tip for Extending Your Engine’s Life

After you start the engine, let your Tiller/Cultivator warm up for two to three minutes before you use it. Then, before you put your Tiller/Cultivator away, let it idle for a minute to give the engine a chance to cool down.

WARNING DANGER

IF ENGINE DOES NOT STOP WHEN SWITCH IS PUT IN THE STOP POSITION, RELEASE THE THROTTLE. ALLOW ENGINE TO IDLE.

PUT THE TILLER/CULTIVATOR DOWN, AND PULL THE CHOKE BUTTON OUT TO COLD START (CLOSED) POSITION.

CHECK AND RETURN IGNITION SWITCH TO ON POSITION BEFORE STARTING ENGINE AGAIN.

13

Image 13
Contents Tiller/Cultivator CV225 Welcome to the World of Redmax Gardening Table of ContentsE c i fi c a t i o n s Special Safety Information Safety Rules and WarningsSafety and Warnings Safety Decal InformationIf the TILLER/CULTIVATOR Precautions Page Engine/ Fuel Warnings Don’ts Engine/ Fuel Warnings Do’sAssembly Instructions Picture II. How to Assemble Lower HandlesImportant Note How to Assemble Upper Handles and Plastic Carrying HandleFuel Mix How to mix fuelRecommended mixing ratio Gasoline 50 Oil Fueling the unitStarting Your Tiller/Cultivator for the First Time Starting InstructionsAdditional Information Starting a Flooded Engine What to do Just in CaseTilling L t iva t i n g How to Switch From Tilling to Cultivating PositionNow You’re Ready to Cultivate or Weed Tilling PositionI n t e n a n c e How to Reseat the Flange MaintenanceHow to Check the Grease Level Inside the Worm-Gear Housing Muffler Procedures to be Performed After Every 100 Hours of UseSpark Arrester Intake Air Cooling VentHours System/ Component Procedure Before EveryO r a g e How to Prepare Your Redmax Tiller/Cultivator for RestartingAgain, Check the Carburetor Check the Spark Plug TooCheck Probable Causes Action Troubleshooting GuideCV225 Parts ListRedMax Cultivator Assembly Redmax Cultivator Assembly Engine Unit CV225 S/N 108000 and up Cylinder Redmax Mini Tiller/Cultivator CV225 2 Year Limited Warranty Il nexiste aucune autre garantie explicite Manufacturers Warranty Coverage 401755 6/07