Poulan 433552, VF550 manual Safety Rules, Training, Preparation, Operation, Maintenance and Storage

Page 2

SAFETY RULES

Safe Operation Practices for Walk-Behind Powered Rotary Tillers

TRAINING

Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

Keep the area of operation clear of all persons, par- ticularly small children, and pets.

PREPARATION

Thoroughly inspect the area where the equipment is to be used and remove all foreign objects.

Disengage all clutches and shift into neutral before starting the engine (motor).

Do not operate the equipment without wearing adequate outer garments. Wear footwear that will improve footing on slippery surfaces.

Handle fuel with care; it is highly flammable.

Use an approved fuel container.

Never add fuel to a running engine or hot engine.

Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

Replace gasoline cap securely and clean up spilled fuel before restarting.

Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by manufacturer).

OPERATION

Do not put hands or feet near or under rotating parts.

Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry passengers.

After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, thoroughly inspect the tiller for any damage, and repair the damage before restarting and operating the tiller.

Exercise caution to avoid slipping or falling.

If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

Stop the engine (motor) when leaving the operating position.

Take all possible precautions when leaving the machine unattended. Disengage the tines, shift into neutral, and stop the engine.

Before cleaning, repairing, or inspecting, shut off the engine and make certain all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting. Disconnect the cord on electric motors.

Do not run the engine indoors; exhaust fumes are dangerous.

Never operate the tiller without proper guards, plates, or other safety protective devices in place.

Keep children and pets away.

Do not overload the machine capacity by attempting to till too deep at too fast a rate.

Never operate the machine at high speeds on slippery surfaces. Look behind and use care when backing.

Never allow bystanders near the unit.

Use only attachments and accessories approved by the manufacturer of the tiller.

Never operate the tiller without good visibility or light.

Be careful when tilling in hard ground. The tines may catch in the ground and propel the tiller forward. If this occurs, let go of the handlebars and do not restrain the machine.

MAINTENANCE AND STORAGE

Keep machine, attachments, and accessories in safe working condition.

Check shear pins, engine mounting bolts, and other bolts at frequent intervals for proper tightness to ensure the equipment is in safe working condition.

Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

Always refer to the operator’s guide instructions for important details if the tiller is to be stored for an ex- tended period.

- IMPORTANT -

CAUTIONS, IMPORTANTS, AND NOTES ARE A MEANS OF ATTRACTING ATTENTION TO IMPORTANT OR CRITICAL INFORMATION IN THIS MANUAL.

IMPORTANT: USED TO ALERT YOU THAT THERE IS A POSSIBILITY OF DAMAGING THIS EQUIPMENT.

NOTE: Gives essential information that will aid you to bet- ter understand, incorporate, or execute a particular set of instructions.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

CAUTION: Always disconnect spark plug wire and place wire where it can- not contact spark plug in order to pre- vent accidental starting when setting up, transporting, adjusting or making repairs.

WARNING

The engine exhaust from this product con- tains chemicals known to the State of Cali- fornia to cause cancer, birth defects, or other reproductive harm.

2

Image 2
Contents VF550 Training Safety RulesMaintenance and Storage PreparationTable of Contents Contents of Hardware Pack AssemblyTools Required for Assembly Tine Operation To Install Depth Stake See FigTilling Width Know Your Tiller Meets Ansi Safety RequirementsOperation Tine Operation See Fig HOW to USE Your TillerStopping See Fig TillingBefore Starting Engine ADD GasolineCultivating Breaking in Your TillerTilling Hints General Recommendations MaintenanceMaintenance Schedule AIR Filter EngineTo Change Engine OIL See Fig Muffler CleaningCooling System See Fig Spark PlugTiller Service and AdjustmentsTo Remove Clutch HOUSING/ENGINE Assembly see FIG Tine ArrangementTo Adjust Carburetor To Replace V-BELT seeFuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionParts and Service
Related manuals
Manual 7 pages 13.6 Kb

433552, 96082001500, VF550 specifications

The Poulan VF550 is a robust and versatile lawn mower designed to cater to the needs of homeowners and professional landscapers alike. Known for its performance and durability, the VF550 is built to tackle various mowing tasks with ease and efficiency.

One of the standout features of the Poulan VF550 is its powerful engine. Equipped with a reliable gas-powered engine, it delivers consistent performance, ensuring that even the toughest grass can be cut without straining the machine. The engine's design focuses on fuel efficiency, allowing users to maximize their mowing time without frequent refuels.

The VF550 features a wide cutting deck, typically around 21 inches, which allows for efficient mowing over larger areas. This broad cutting path reduces the number of passes needed to achieve a well-manicured lawn, saving both time and energy. The adjustable cutting height feature is another practical characteristic, allowing users to customize the grass length according to their preferences or the specific requirements of their lawn.

Another essential aspect of the Poulan VF550 is its innovative cutting technology. The mower is equipped with a precision cutting system that ensures a clean and even cut. This not only enhances the appearance of the lawn but also promotes healthier grass growth by minimizing damage to the blades of grass during mowing.

User comfort and ease of use are paramount in the design of the VF550. The mower features ergonomic handles that provide a comfortable grip, reducing fatigue during extended use. Additionally, its lightweight construction makes it easy to maneuver around obstacles, while its compact design allows for easy storage.

Maintenance is greatly simplified in the Poulan VF550. The easy-access engine compartment enables quick maintenance checks and tasks, such as oil changes and air filter replacements. This focus on user-friendliness ensures that the VF550 remains a practical tool for maintaining a beautiful lawn.

Overall, the Poulan VF550 combines reliability, performance, and convenience in one package. Its powerful engine, wide cutting deck, and advanced cutting technology make it an excellent choice for anyone looking to keep their lawn in pristine condition. With features designed for ease of use and low maintenance requirements, the VF550 stands out as a top-tier lawn mower in its class.