Troy-Bilt 644H-Bronco, 645A-Bronco manual Clearing the tines, Tilling on slopes

Page 17

Section 4: Operation

Tilling Tips & Techniques

Clearing the tines

Dry grass, stringy stalks or tough vines may become tangled in the tines. Follow these procedures to help avoid tangling and to clean the tines, if necessary.

To reduce tangling, set the depth regulator to maximum depth.

While tilling, try swaying the handle- bars from side to side (about 6" to 12"). This “fishtailing” action often clears the tines of debris.

If tangling occurs, lift the tines out of the soil and run the tiller in reverse for a few feet. This may unwind a good deal of debris.

It may be necessary to remove the debris by hand (a pocket knife will help you to cut away the material).

WARNING

Before clearing the tines by hand, stop the engine, allow all moving parts to stop and disconnect the spark plug wire.

Failure to follow this warning could result in personal injury.

Tilling on slopes

If you must garden on a moderate slope, please follow two very important guide- lines:

1.Till only on moderate slopes, never on steep ground where footing is difficult (review safety rules in the “Safety” section of this manual).

2.We recommend tilling up and down slopes rather than terracing. Tilling vertically on a slope allows maximum planting area and also leaves room for cultivating.

IMPORTANT: When tilling on slopes, be sure the correct oil level is maintained in the engine (check every one-half hour of operation). The incline of the slope will cause the oil to slant away from its normal level and this can starve engine parts of required lubrication. Keep the engine oil level at the full point at all times!

A. Tilling up and down slopes:

To keep soil erosion to a minimum, be sure to add enough organic matter to the soil so that it has good moisture- holding texture and try to avoid leaving footprints or wheel marks.

When tilling vertically, try to make the first pass uphill as the tiller digs more deeply going uphill than it does downhill. In soft soil or weeds, you may have to lift handlebars slightly while going uphill.

B. Tilling across slopes without using terraces:

If previously described tilling methods aren’t practical for you, then you can till laterally across a slope. However, we don’t really recommend this method as it can create unsure footing and invites soil erosion.

17

Image 17
Contents Operator’s Manual Table of Contents Ments or inspections SafetyUse a deep depth regulator setting Use slower engine speeds SafetyKeep children and pets away Never operate the tiller underDecals Operating SymbolsTools/Materials Needed for Assembly AssemblyLoose Parts List Qty. Description IntroductionMove Tiller Off Shipping Platform AssemblyAttach Handlebar Install Forward Clutch Cable Install Reverse Clutch CableCheck Hardware for Tightness Check Level Transmission Gear OilCheck Air Pressure in Tires Tiller is shipped without oil in the engineWheel Drive Pins Features and ControlsForward Clutch Bail Depth Regulator Reverse Clutch Control Anti-Reverse StakeReverse Clutch Control Forward Clutch BailTo Operate the Forward Clutch Bail To Operate the Reverse Clutch ControlHandlebar Height Adjustment Features and ControlsDepth Regulator Lever Anti-Reverse StakeIntroduction OperationInitial Operation Starting and Stopping the EngineOperation Use the Fast throttle speed setting when tillingOperating the Tiller Starting the EngineStopping the Tiller and Engine Turning the Tiller AroundFor reverse motion of the wheels and tines Tilling depths Let the tiller do the workAvoid tilling soggy, wet soil Avoid making footprintsClearing the tines Tilling across slopes without using terracesTilling on slopes Tilling up and down slopesLoading and Unloading the Tiller Required Maintenance Schedule MaintenanceEvery HoursTransmission Gear OIL Service MaintenanceTiller Lubrication Check for OIL LeaksRemoving and Installing Individual Tines Removing and Installing Tine AssembliesTines Tine InspectionTo Check Forward Belt Tension PositionTo Check Reverse Belt Tension Forward Clutch Bail AdjustmentReverse Belt Replacement Information AIR Cleaner Service Engine OIL ServiceSpark Plug Service Engine CleaningTroubleshooting TROY-BILT LLC, P.O. Box 361131, Cleveland, Ohio 44136-0019 TROY-BILT Tiller Lifetime Limited Warranty