Crown Audio 2650 Specification s, Ohms 400W rms 650W rms 850W rms, Ohms 800W rms 1300W rms

9 . 0	S p e c i f i c a t i o n s
Power Ratings	Pulse 2x650

Stereo

Measured per channel, both channels driven at 1kHz to no more than 0.1% THD+N

8 ohms	400W rms
4 ohms	650W rms
2 ohms	850W rms*
* Note: 2 ohm spec is at 1% THD
Bridged Mono
16 ohms	800W rms
8 ohms	1300W rms
4 ohms	1700W rms*

* Note: 4 ohm bridged spec is at 1% THD

Input Sensitivity	+1dBu for full output
Input Impedance	20 kohm
Input Connectors	1/4-inch TRS balanced phone jack, removable terminal block,
	male and female XLR
Distortion	<0.006% THD, 1kHz, 1dB below clip, 22kHz measurement bandwidth
Frequency Response	20Hz to 20kHz, +0/-0.2dB; <2Hz to >120kHz +0/-3dB
Controls	Power switch, bridge mode switch, indented level controls (these may be made
	tamper-proof)
Indicators	AC Present, Operate, Signal, Bridge, Clip, Temp., Fault
Protection	Microprocessor supervised: Over-temperature, DC on outputs, output stage
	overload, inrush current surge, power fail and brownout
Noise	<-100dBref full output 20Hz - 20kHz measurement bandwidth
Slew Rate	>50 V/microsecond
Damping Factor	>200 ref 8 ohm
Output Connectors	Binding post and Speakon®
AC Power	230 volts AC nominal, 2200VA, all channels driven
Dimensions	3.5" (89mm) x 18.2" (460mm) x 19" (483mm)
Weight	24lbs (11kg)

17