ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) Utility knife
(1)Tire pressure gauge
(1)Pair of pliers
(1)9/16" wrench
OPERATOR’S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).
FRONT
LEFT | RIGHT |
| overhead views 10 |
OPERATOR’S
POSITION
FIG. 1
CONTENTS OF HARDWARE PACK
(2) Handle Lock | (1) Carriage Bolt | (1) Center Locknut |
| ||
| ||
|
|
(1) Flat Washer 13/32 x 1 x 11 Ga. | (1) Cable Clip | (1) Handle Lock Lever |
(1) Hairpin Clip | (1) Pivot Bolt |
|
| (2) Shear Pins & Clips | |
|
|
4