Poulan 427896 manual Safety Rules, Training, Preparation, Operation, Maintenance and Storage

Page 2

SAFETY RULES

Safe Operation Practices for Walk-Behind Powered Rotary Tillers

TRAINING

Read the Owner’s Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

Keep the area of operation clear of all persons, par- ticularly small children, and pets.

PREPARATION

Thoroughly inspect the area where the equipment is to be used and remove all foreign objects.

Disengage all clutches and shift into neutral before starting the engine (motor).

Do not operate the equipment without wearing ade- quate outer garments. Wear footwear that will improve footing on slippery surfaces.

Handle fuel with care; it is highly flammable.

Use an approved fuel container.

Never add fuel to a running engine or hot engine.

Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

Replace gasoline cap securely and clean up spilled fuel before restarting.

Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by manufacturer).

OPERATION

Do not put hands or feet near or under rotating parts.

Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry passengers.

After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, thoroughly inspect the tiller for any damage, and repair the damage before restarting and operating the tiller.

Exercise caution to avoid slipping or falling.

If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

Stop the engine (motor) when leaving the operating position.

Take all possible precautions when leaving the machine unattended. Disengage the tines, shift into neutral, and stop the engine.

Before cleaning, repairing, or inspecting, shut off the engine and make certain all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting. Disconnect the cord on electric motors.

Do not run the engine indoors; exhaust fumes are dangerous.

Never operate the tiller without proper guards, plates, or other safety protective devices in place.

Keep children and pets away.

Do not overload the machine capacity by attempting to till too deep at too fast a rate.

Never operate the machine at high speeds on slippery surfaces. Look behind and use care when backing.

Never allow bystanders near the unit.

Use only attachments and accessories approved by the manufacturer of the tiller.

Never operate the tiller without good visibility or light.

Be careful when tilling in hard ground. The tines may catch in the ground and propel the tiller forward. If this occurs, let go of the handlebars and do not restrain the machine.

MAINTENANCE AND STORAGE

Keep machine, attachments, and accessories in safe working condition.

Check shear pins, engine mounting bolts, and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.

Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

Always refer to the operator’s guide instructions for important details if the tiller is to be stored for an ex- tended period.

- IMPORTANT -

CAUTIONS, IMPORTANTS, AND NOTES ARE A MEANS OF ATTRACTING ATTENTION TO IMPORTANT OR CRITICAL INFORMATION IN THIS MANUAL.

IMPORTANT: USED TO ALERT YOU THAT THERE IS A POSSIBILITY OF DAMAGING THIS EQUIPMENT.

NOTE: Gives essential information that will aid you to better understand, incorporate, or execute a particular set of instructions.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

CAUTION: Always disconnect spark plug wire and place wire where it can- not contact spark plug in order to pre- vent accidental starting when setting up, transporting, adjusting or making repairs.

WARNING

The engine exhaust from this product con- tains chemicals known to the State of Cali- fornia to cause cancer, birth defects, or other reproductive harm.

2

Image 2
Contents HDF900 Operators Manual ModelTraining Safety RulesMaintenance and Storage PreparationTable of Contents Contents of Hardware Pack AssemblyTools Required for Assembly Tilling Width Unpack Carton & Install Handle See FigHandle Height Tine OperationKnow Your Tiller Meets Ansi Safety RequirementsOperation Tilling HOW to USE Your TillerStopping See Fig TinesFill Engine with OIL see Fig To TransportBefore Starting Engine ADD GasolineCultivating Breaking in Your TillerTilling Hints General Recommendations MaintenanceLubrication Chart Before Each USETo Change Engine OIL See Figs AIR Cleaner See FigEngine Muffler CleaningCooling System See Fig Spark PlugTiller Service and AdjustmentsTo Adjust Handle Height See Fig Tine ArrangementTo Remove Belt Guard See Fig To Adjust CarburetorTine Operation Check See Fig Final Check OFF PositionBelt Removal Belt ReplacementTo Replace V-BELT See Fig Check Tine OperationFuel System StorageOther Engine OILTroubleshooting Points Will not startService Notes Limited Warranty Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Articles des fabricant du Dept Service Customer Canada AuInitiale d’achat date la de compter à jours Dentretien Remarques Dépannage DE Guide LabourageMoteur DE Huile EntreposageCylindres Dalimentation SystèmeLedazoïpétra Courroie LA Remplacer Réglages ET RévisionFig la Voir Sesfrai DES Dutilisation Vérification Fig la Voir RoieCour DE Protecteur LE Enlever Pour Marche Position Vérification DerniéreFig la Voir Guidon DU Hauteur LA Régler Pour MotobineuseFraises DES Disposition 15 .Fig Carburateur LE Régler PourSilencieux Entretien’ALLUMAGE Bougie Refroidissement DE SystèmeMoteur Dhuile Remplacer Pour Fig la Voir AIR À FiltreLubrification Air/essence mélange un assurent propre air à filtre nouveau Utilisation Chaque AvantTempslong plus durer de et Motobineuse LA DE Rodage UtilisationLabourage DE Conseils Culture’ESSENCE Réservoir LE Remplir Fig la Voir Moteur DU Démarrage’HUILE Moteur DU Remplissage Moteur DU Démarrage LE AvantTransporter Pour LabourageFig la Voir Arrêt Dents DES FonctionnementMoteur du commutateur Le -MOTEUR DU Commutateur Un démarrer pour employé Létrangleur DE CommandeMotobineuse Votre Ouvre carburant de soupape La Carburant DE RobinetGeraboula DU Largeur Manche LE Installer ET DéballerMontage Dents DES UtilisationMontage LE Pour Exiges Outils LES Pièces DES SAC DU ContenuFig la Voir D’OPERATEUR Position De Clés 2 Pince 1 Tournevis 1 usage tout à CouteauClient DU Responsabilités SommaireProduit DU Spécifications Réglages ET Révision Client DU ResponsabilitésMotobineuses des Sécurité toute Sécurité DE RèglesEntreposage ET Entretien En lUtilisation pour ConseilsModèle Opérateur DU Manuel