McCulloch 532 43 36-95, MHDF800 manual Tools Required for Assembly, Contents of Hardware Pack

Page 4

ASSEMBLY

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)Utility knife

(1)Screwdriver

(2)1/2" wrenches

OPERATOR’S POSITION (See Fig. 1)

When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).

	FRONT
	overhead views 8
LEFT	RIGHT

OPERATOR'S POSITION

Fig. 1

CONTENTS OF HARDWARE PACK

(2) Hex Bolts 5/16-18 x 1

(4) Washers 3/8 x 7/8 x 14

(4) Hex Bolts 5/16-18 x 1-1/4

(6) Lock Washers 5/16

(6) Hex Nuts 5/16-18

Image 4

Contents MHDF800 Safety Rules Maintenance and StorageTraining PreparationTable of Contents Tools Required for Assembly AssemblyContents of Hardware Pack Unpack Carton & Install Handle See Fig Handle HeightTilling Width Tine OperationOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Stopping See FigTine Operation See Fig TillingBefore Starting Engine To TransportFill Engine with OIL See Fig ADD GasolineTilling Hints Breaking in Your TillerCultivating Maintenance Lubrication ChartGeneral Recommendations Before Each USEEngine AIR Cleaner See FigCooling System See Fig Cleaning Service and AdjustmentsTiller Tine Operation Check See Fig To Remove Belt Guard See FigTo Replace V-BELTS See Figs Final Check OFF PositionTo Adjust Carburetor Belt ReplacementBelt Removal Check Tine OperationStorage OtherFuel System Engine OILTroubleshooting Points Service Notes Limited Warranty