Bolens 520, 350E, 300E, 330, 225E, 500E manual Troubleshooting, Problem Cause Remedy

Page 12

SECTION 7: TROUBLESHOOTING

Problem

 

Cause

 

Remedy

 

 

 

 

 

Engine fails to start

1.

Spark plug wire disconnected.

1.

Connect wire to spark plug.

 

2.

Fuel tank empty or stale fuel.

2.

Fill tank with clean, fresh gasoline.

 

3.

Throttle control lever not in correct

3.

Move throttle lever to start position.

 

 

starting position. (If equipped)

4.

Move lever to ON position.

 

4.

Choke not in ON position.

 

5.

Blocked fuel line.

5.

Clean fuel line.

 

6.

Faulty spark plug.

6.

Clean, adjust gap, or replace.

 

7.

Engine flooded

7.

Wait a few minutes to restart, but do not

 

 

 

 

prime. (If Equipped)

Engine runs erratic

1.

Spark plug wire loose.

1.

Connect and tighten spark plug wire.

 

2.

Unit running on CHOKE.

2.

Move choke lever to OFF position.

 

3.

Blocked fuel line or stale fuel.

3.

Clean fuel line; fill tank with clean, fresh

 

 

 

 

gasoline

 

4.

Vent plugged.

4.

Clear vent.

 

5.

Water or dirt in fuel system.

5.

Drain fuel tank. Refill with fresh fuel.

 

6.

Dirty air cleaner.

6.

Clean following engine manual.

 

7.

Carburetor out of adjustment.

7.

Refer to engine manual.

Engine overheats

1.

Engine oil level low.

1.

Fill crankcase with proper oil.

 

2.

Dirty air cleaner.

2.

Clean air cleaner.

 

3.

Air flow restricted.

3.

Remove blower housing and clean.

 

4.

Carburetor not adjusted properly.

4.

Refer to engine manual.

Tines do not engage

1.

Foreign object lodged in tines.

1.

Stop tiller completely, check and

 

 

 

 

discard foreign object.

 

2.

Tine clevis pin(s) missing.

2.

Replace tine clevis pin(s).

 

3.

Control cable not adjusted properly.

3.

Adjust control cable.

 

4.

Belt worn and/or stretched.

4.

Replace belt.

 

5.

Pulley and idler not in correct

5.

Take unit to authorized service dealer.

 

 

adjustment.

 

 

NOTE: For repairs beyond the minor adjustments listed above, contact your nearest service dealer.

12

Image 12
Contents OPERATOR’S Manual Table of Contents Important Safe Operation Practices TrainingPreparation OperationMaintenance & Storage Your ResponsibilityBefore Assembly Assembling The Handle Assembling Your TillerTo Remove Unit From Carton Loose Parts In CartonCheck Cable Adjustment Tine Clutch Control Handle Adjustment LeverKnow Your Tiller Depth StakeOperating Your Tiller Controlling Speed And Tilling Depth Making Adjustments Cleaning Tine Area Belt ReplacementMaintaining Your Tiller EngineOff-Season Storage Troubleshooting Problem Cause RemedyPage Model Series 300 Part Description Model Series Model Series Model Series Model Series MANUFACTURER’S Limited Warranty for