UNPACKING CARTON (See Fig. 2)
staples when handling or disposing of
CAUTION: Be careful of exposed cartoning material,
IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLES.
•While holding handle assembly, cut cable ties securing handle assembly to top frame and depth stake.. Let handle assembly rest on tiller,
o Removetop frame ofcartono
. Slowly ease handle assembly up and place on top of carton°
. Cut down right hand front and right hand rear corners of carton, lay side carton wall down.
°Remove packing material from handle assembly.
°Separate shift rod from handle assembly_
SHIFT ROD
\
HANDLE
ASSEMBLY
FIG. 2
INSTALL HANDLE (See Figs. 3, 4, and 5)
°Insert one handle lock (with teeth facing outward) in gearcase notch, (Apply grease on smooth side of handle lock to aid in keeping lock in place until handle assembly is lowered into position°)
HANDLE ASSEMBLY
oGrasp handle assembly, Hold in"up" position. Be sure handle lock remains in gearcase notch. Slide handle assembly into position_
"UP" POSITION |
LOCKLEVERTO
HOLDTIGHTEN HANDLE 1
FIG. 4
°Rotate handle assembly down to install two carriage boIts and Iocknuts, Insert rear carriage bolt (Fig° 5) first, with head of bolt on L.H. side of tiller° Lower the handfe
assembly,, Tighten bolts so handle moves with some resistance°
°Place flat washer on threaded end of handle lock lever°
°Insert handle lock lever through handle base and ghearcaseo Screw in handle lock lever just enough to
old lever in place,,
°Insert second handle lock (with teeth inward) in the slot of the handle base (just inside of washer)_
°With handle assembly in lowest position, securely tighten handle lock lever by rotating clockwise. Leav- ing handle assembly in _owest position will make it easier to remove tiller from carton.
| HANDLE |
| LOCK |
SLOT | FLAT |
CARRIAGE | WASHER |
| |
BOLT |
|
| HANDLE |
| LOCK |
| LEVER |
REAR
CARRIAGE
BOLT
LOCKNUTS
HANDLE
BASE
FIG. 5
FIG. 3