UNPACK CARTON & INSTALL
HANDLE
A, CAUTION: Be careful of exposed sta- ples when handling or disposing of carton- ing material.
IMPORTANT: When unpacking and as- sembling tiller, be careful not to stretch or kink cable(s).
•Cut cable ties securing handle column.
•Slowly lift handle column up and slip over handle mount.
•Remove packing from carton.
•Secure handle column to handle mount using two (2) carriage bolts and two (2) flange Iocknuts. Tighten both flange
Iocknuts securely.
•Remove packing material from handle assembly.
•Insert plastic cable clip into hole in han- dle column.
•Route fine control cable through plastic cable clip on handle column.
•Cut away carton.
:Cut cable ties securing tiller to skid. Remove tiller from skid by pulling back- wards.
Tine
Tine Control Cable
Handle Mount | Column |
"line Control
Cable •
cable
clip
Carriage
Bolts Flange Iocknuts
\ | Engine Bracket Halves |
|
Nut "A"
Depth Stake
\
Stake
Support Bolt
lex Bolts Lockwashers
and Rex nuts
HANDLE HEIGHT
•Handle height may be adjusted to better suit operator. (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual).
TILLING WIDTH
•Tilling width may be adjusted to better
handle your tilling conditions (See "TINE
ARRANGEMENT" in the Service and Adjustments section of this manual).
TINE OPERATION
•Check tine operation before first use. (See "TiNE OPERATION CHECK" in the
Service and Adjustments section of this manual).
INSTALL DEPTH STAKE ASSEMBLY
,• Loosen nut "A".
•Insert stake support between engine bracket halves with stake spring down.
with bolts, lock washers and nuts.
i Tightenolt stakesecurelysupport. "13ghtennutto engine brackets"A". ; Depth stake must move freely. If it doe_
not, loosen support bolt.
!' 6