UNPACK CARTON & INSTALL HAN-
DLE
_CAUTION: Be careful of exposed sta-
ples when handling or disposing of carton- ing material.
IMPORTANT:: When uNpacking and as- sembling tiller, be careful not to stretch or kinK cable(s).
= Cut cable ties securing handles.
o The handle may be assembled in high or low position,, Slowly lift handle as- sembly up and align handle holes with desired handle panel hole and slot.
=Loosely assemble hardware as shown.
Be sure the "
shorter (3/4" long) hex bolt is assembled in lower hole of handle, Repeat for
opposite side. Tighten all hardware se- curely.
o Cut cable ties securing tiller to skid and
remove tiller from | skid, |
|
Handle Panel | _ | ..Lock Washer |
v |
|
|
|
|
|
Handle
Panel Bolts
Engine Bracket Halves
Nut "A"
/
Depth Stake
Support
_X Stake b/ Support Bolt
Stake Spring
Hex Bolt_ Lockwashers, and Hex nuts
HANDLE HEIGHT
o Handle height may be adjusted to better suit operator: (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual).
TILLING WIDTH
=Tilling Width may be adjusted to better handle your tilling conditions (See "TINE ARRANGEMENT' in the Service and Adjustments section of this manual)°
TINE OPERATION
o Check tine operation before first use, (See 'q'INEOPERATION CHECK" in the Service and Adjustments section of this
manual),
INSTALL DEPTH STAKE ASSEMBLY o Loosen nut "A".
o Insert stake support between engine bracket halves with stake spring down,
o Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely, Tighten nut "A",
•Depth stake must move freely. If it does not, loosen support bolt.
6