Husqvarna FT900 owner manual Table of Contents

Page 3

PRODUCT SPECIFICATIONS

Gasoline Capacity:

3 Quarts (2.8L)

 

Unleaded Regular

 

 

Oil (API-SG-SL):

SAE 30 (Above 32°F/0°C)

(Capacity: 21 oz./0.6L)

SAE 5w30 (Below 32°F/0°C)

Spark Plug :

Champion RC12YC

 

(Gap: .030"/0.76mm)

CONGRATULATIONS on your purchase of a new tiller. It has been designed, engineered and manufactured to give you the best possible dependability and performance.

Should you experience any problems you cannot easily remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and the proper tools to service or repair this unit.

Please read and retain this manual. The instructions will enable you to assemble and maintain your tiller properly. Always observe the “SAFETY RULES”.

CUSTOMER RESPONSIBILITIES

Read and observe the safety rules.

Follow a regular schedule in maintaining, caring for and using your tiller.

Follow instructions under “Maintenance” and “Storage” sections of this Owner’s Manual.

IMPORTANT: THIS UNIT IS EQUIPPED WITH AN INTERNAL COMBUSTION ENGINE AND SHOULD NOT BE USED ON OR NEAR ANY UNIMPROVED FOREST-COVERED, BRUSH- COVERED OR GRASS COVERED LAND UNLESS THE ENGINE'S EXHAUST SYSTEM IS EQUIPPED WITH A SPARK ARRESTER MEETING APPLICABLE LOCAL LAWS (IF ANY). IF A SPARK ARRESTER IS USED, IT SHOULD BE MAINTAINED IN EFFECTIVE WORKING ORDER BY THE OPERATOR.

IN THE STATE OF CALIFORNIA, A SPARK ARRESTER IS REQUIRED BY LAW (SECTION 4442 OF THE CALIFORNIA PUBLIC RESOURCES CODE). OTHER STATES MAY HAVE SIMILAR LAWS. FEDERAL LAWS APPLY ON FEDERAL LANDS. SEE YOUR AUTHORIZED SERVICE CENTER/DEPARTMENT FOR SPARK ARRESTER.

TABLE OF CONTENTS

SAFETY RULES

2

MAINTENANCE

10-12

CUSTOMER RESPONSIBILITIES

3

SERVICE & ADJUSTMENTS

13-15

PRODUCT SPECIFICATIONS

3

STORAGE

16

ASSEMBLY

4-5

TROUBLESHOOTING

17

OPERATION

6-9

REPAIR PARTS

18-23

MAINTENANCE SCHEDULE

10

WARRANTY

24-27

3

Image 3
Contents FT900 Preparation Safety RulesMaintenance and Storage TrainingTable of Contents Assembly Tools Required for AssemblyContents of Hardware Pack Tilling Width Unpack Carton & Install Handle See FigInstall Depth Stake Assembly See Fig Handle HeightMeets Ansi Safety Requirements OperationKnow Your Tiller Tilling HOW to USE Your TillerStopping See Fig Tine Operation See FigADD Gasoline Before Starting EngineTo Transport Fill Engine with OIL See FigBreaking in Your Tiller Tilling HintsCultivating Maintenance Maintenance ScheduleGeneral Recommendations Engine AIR Cleaner See FigSpark Plug CleaningCooling System See Fig MufflerTine Arrangement Service and AdjustmentsTo Adjust Handle Height See Fig TillerTo Remove Belt Guard See Fig Tine Operation Check See FigTo Replace V-BELTS See Figs To Adjust Carburetor Check Tine OperationReplace Belt Guard Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsKEY Part Description Handle AssemblyBelt Guard and Pulley Assembly   Wheel and Depth Stake AssemblyTineipb3 Tine AssemblyKEY Part NO. NO. Description Decals Limitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Qjlqh 7UDQVPLVVLRQ 01.25.11 BAD
Related manuals
Manual 28 pages 12.55 Kb