Pentair Legend II installation manual Back Washing the Pool Filter

Page 12

III.Operation/Periodic Maintenance - (cont.)

2. Tires & Bearings

The tires are designed to protect the bottom of your pool and provide better traction. You need to rotate or replace the tires when edges become rounded.

The Wheel Bearings are warranted free of defects when shipped from Pentair Water Pool and Spa, Inc., and are considered a wear item. A good bearing will spin freely.

3. Roller Rings

Your Sweep Hose has a series of Roller Rings to protect the Sweep Hose. Replace the rings as needed. You can rotate the Roller Rings to prevent flat spots.

4. Debris Bags

Fine Mesh Sand & Silt Bag

The Legend® II comes with a Sand & Silt bag for general use in all pools. We do not recommend using the fine mesh bag to pick up leaves and twigs or other large debris for they have sharp points and edges that can poke holes and eventually rip the bag.

Optional Leaf Bag

The leaf bag is a larger mesh bag made to pick up heavier debris such as leaves. twigs, acorns, etc. This bag can be helpful especially after a storm.

A Helpful Hint: To prolong the life of bags, remove cleaner from pool before adding chemicals.

5. Sweep Hose

The Sweep Hose is provided to help keep the bottom and sides of your pool clean. The Sweep Hose is warranted free of defects when shipped from the factory, and is considered a wear item.

6. Debris Valve

This valve is located under the Debris Bag, it is designed to keep the debris inside the bag. It functions like a check valve to allow the debris to only enter through the bag one way. Replacement is needed when valve begins to stiffen.

E. Back Washing the Pool Filter

Always disconnect the Legend® II from the pool wall before cleaning or back washing the pool filter. After cleaning or back washing, let the pool filtration system run for a minimum of five minutes to flush out the return lines before reconnecting the Legend® II.

8

LEGEND® II INSTALLATION MANUAL

Image 12
Contents Installation Guide Customer Service Web siteImportant Information Serial #Table of Contents Thank You for Choosing the Legend II Pool Cleaner What to Expect from the LegendInstalling the Twist Lock Pressure Relief Valve Wall Fitting Pool ConnectionsPressure Testing Instructions Cutting the Feed Hose See Hose Diagram onHooking up the Legend Checking Operation Fine Tuning the Legend Thrust Jet Adjustment Sweep Hose Adjustment Checking Wheel RPMChecking RPM Connecting/Disconnecting the Legend Turning On/Off the Legend Cleaning the Sand & Silt BagPeriodic Maintenance Wall Fitting ScreenBack Washing the Pool Filter Accessories Storage and WinterizingLeaf Bag Step AdapterIV. Troubleshooting and Performance Tips Problems & Solutions Tips on Hose Cutting for Larger Pools Tips on Hose Cutting for Smaller PoolsLXU5 LXU8 Exploded View