Jacuzzi E-1451 owner manual Inspection, Important Safety Instructions, Installation Location

Page 1

Jacuzzi®

Magnum, RC, LR, Cygnet

E-1451

Owner’s Manual

Before installation, be sure to read all instructions and warnings carefully.

Refer to product dataplate(s) for additional operating instruction and specifications.

Inspection

Examine the equipment when received. Notify your dealer or carrier of any damage or missing parts. Verify that equipment is of size and model specified.

Important Safety Instructions

When installing and using this electrical equipment, basic safety precations should always be followed, including the following:

1.READ AND FOLLOW ALL INSTRUCTIONS.

2.WARNING – To reduce risk of injury, do not permit children to use this product unless they are closely supervised at all times.

3.WARNING – (For cord & plug connected units). Risk of Electrical Shock. Connect only to a grounding type receptacle protected by a ground-fault circuit- interrupter (GFCI). Contact a qualified electrician if you cannot verify that the receptacle is protected by a GFCI.

4.WARNING – (For cord & plug connected units). Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge trimmers and other equipment.

5.WARNING – (For cord & plug connected units). To reduce the risk of electric shock, replace damaged cord immediately.

should be on a hard, level surface. Give consideration to:

6.WARNING – (For cord & plug connected units). To reduce the risk of electrical shock do not use an extension cord to connect unit to electrical supply; provide a properly located outlet.

7.CAUTION – (For pumps with a 25 ft. (7.62m cord). This pump is for use with storable pools only. Do not use with permanently installed pools. A storable pool is constructed so that it may be readily disassembled for storage and reassembled to its original integrity. A permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage.

8.CAUTION – (For pumps with/without 3ft. (.91m cord). This pump is for use with permanently installed pools and may also be used with hot tubs and spas if so marked. Do not use with storable pools. A permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it may be readily disassembled for storage and reassembled to its original integrity.

9.WARNING – (For hot tub and spa pumps). Do not install within an outer enclosure or beneath the skirt of the hot tub or spa, unless so marked.

10.SAVE THESE INSTRUCTIONS!

Installation Location

Locate pump as close to pool/spa as possible, preferably in a dry, well ventilated area away from direct sunlight. It should be on a hard, level surface. Give consideration to:

the pump discharge. The valves are essential for pump

Image 1
Contents Installation Location Important Safety InstructionsInspection Read and Follow ALL InstructionsPump Plumbing General PlumbingElectrical Data Pump Start UpFIG. no Description Parts for Models RC, URC, RTC, Urtc Parts Diagram for LR, LR9 LRX, LRT, LR3, LR6, LR25, LVL IMP ¾ HP Parts Diagram for CygnetIMP 1 HP IMP 1½ HPCleaning Pump MaintenanceService & Repair Parts Trouble ShootingJacuzzi Bros