21.Apply blocks to vehicle when parked on an incline.
22.
23.Not to be used for aircraft purposes.
Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that the following parts are included.
Clutch Knob (17)
Remote Control (26)
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Installation
Warning: Injury or death could occur if this Electric Winch comes apart from its mount- ing location when it is under load. For that reason, it should only be installed by a qualified technician.
1.Align the Winch on the vehicle mounting frame (not supplied). Make drill marks through the mounting holes.
It should be aligned and secured to a solid, flat part of the vehicle (capable of supporting the Winch and load capacity) where the full rated load will be evenly distributed. Also remember that the Winch is designed for horizontal pull, not vertical.
Mounting Holes
2.Remove the Winch and drill two 5/16 inch holes through the vehicle mounting frame.
3.Secure the Winch to the vehicle mounting frame using Mounting Nuts, Bolts, and Lock Washers (not supplied). Securely tighten.
SKU 90282 | Page 5 | REV 04/04 |