Electric Start, Battery Kit Parts List

ELECTRIC START

This generator model is provided with both electric start and recoil start capabilities. The charger is a low amperage (1A) maintenance type charger. It will charge your battery as your generator runs. Avoid prolonged cranking, as it can damage the engine.

The battery provided is a nominal 12 volt sealed rechargeable lead-acid battery and can be operated in any position without leakage. It complies with non-spillable battery regulations. Its convenient size offers a 30% reduction over conventional batteries.

Length = 7.14 inches, Width = 3.03 inches, Height = 6.59 inches, Weight = 12.56 lbs 18AH Rating

UL Recognized

Battery Kit Parts List

Item	Description		Qty

A	*Bolt, M5 x M12	2
B.	*Nut 5MM	2
C.	*Washer Flat M5	2
D.	*Bolt, 1/4-20 X 8”	2
E.	*Washer 1/4	2
F.	*Spacer	2
G.	Hold Down bar (P/N 0036525.02)	1
H.	*Wing nut, 1/4-20	2

*These are standard parts available at your local hardware store.

Note: Brand New Generators are shipped with the Battery Connections disconnected. The Positive and Negative Terminals must be connected to the Battery before the Electric Start Feature will work.

Initial Battery Connection - Refer to the Installation Instructions Below.

Battery Removal & Installation:

Removal: Remove the nut and bolt from the negative and positive post, being careful not to short across the terminals. (Shorting the terminals together can cause sparks, damage to the battery or generator or even burns or explosions.) Always abide by the safety warnings provided with the battery. Remove the battery and re-cycle and dispose of properly.

Installation:

1.Place the battery in the position provided.

2.Place the bolts through the holes on the battery pan.

3.Place the bolts through the loops on the Hold-Down bracket.

4.Place the spacers and washers on the bolts.

5.Tighten down the Hold-Down assembly with the 1/4-20 nuts provided.

Note: Spacers may be removed depending on the battery height.

Hook up the new battery, or re-install the new battery, as follows: Remove vinyl caps from red and black wire terminals. Connect the Red 10 Gauge wire to the positive (+) terminal and the Black 10 Gauge wire to the negative (-) terminal with the bolt, nut, and washer provided. Make sure all connections are tight. Your battery is now connected and ready for use. Turn the key switch to crank the engine.

Note: Be sure Oil has been added to the engine as specified in the Owner's Manual.

•Do not short-circuit the battery terminals.

•Do not charge in a sealed container.

•Keep sparks, flame away.

			English
	4