Installation Guide
8 Feed Conduit and Wires
Silicone
Caulk
The outer diameter of the
conduit connector is
8.From the inside of the house, feed the end of the 30- foot conduit (INCLUDED and
9 | Threaded Lock Nut |
|
|
The outer diameter of the threaded end is 15/16 inches.
9.Remove the threaded lock nut from the conduit coupling.
11. Using | appropriate | 11 | Mount External Connection Box | ||
fasteners, | mount |
|
| ||
|
| ||||
external | connection | ||||
box over | |||||
hole | to | fully | conceal | ||
the hole. (Seal around | |||||
the hole and conduit | |||||
with | silicone caulk | ||||
from | both | outside | |||
and inside of house.) | |||||
The external connection box must be locked to ensure safety and to discourage tampering.
12 Mounting Automatic Transfer Switch
1ft.
12. Locate automatic transfer switch with |
emergency load center within one foot of main |
distribution panel. The automatic transfer switch can |
be located to the left or right of main distribution |
1010 ConnectWires
Knockout
10.Remove the knock out in the lower right corner of the external connection box. From the rear of the connection box, feed wires & 4 pin plug into box. Slip the lock nut over wires and plug and tighten securely onto conduit coupling. Connect the black, red, and white wires to separate threaded lugs and tighten securely. Screw the green ground wire securely to the bottom of the box. NOTE:
THE
panel. Hold transfer switch against the mounting |
surface. Level the transfer switch and mark the |
mounting holes. Drill the appropriate size pilot holes. |
Mount the automatic transfer switch to mounting |
surface with appropriate fasteners. |
DANGER: Although you may choose to perform electrical connections yourself, Generac Power Systems, Inc. recommends that a licensed electrician or individual with complete knowledge of electricity perform the procedures in sections 13 and 14.
DANGER: Switch service main circuit breaker to “off” or open position prior to removal of cover or removal of any wiring of
the main electrical distribution panel. The “OFF” wires connected to the service main circuit
breaker remain live or “hot”. Avoid contact with these wires and the service main circuit breaker connection lugs.
4