Generac 9801-7 owner manual Volt, 20 Amp Locking Type Receptacle, Volt DC, 10 Amp Receptacle

10000EXL Extended Life Generator

120 Volt, 20 Amp Locking Type Receptacle

Use a NEMA L5–20 plug with this receptacle. Connect a 3–wire cord set rated for 125 Volt AC loads at 20 Amps to the plug (Figure 14).

Figure 14 — 120 Volt AC, 20 Amp, Locking Receptacle

3-Wire Cord Set

NEMA L5-20

Neutral

120V

Hot

Ground (Green)

Use this receptacle to operate 120 Volt AC, 60 Hz, single phase loads requiring up to 2,400 watts (2.4 kW) of power at 20 Amps.The outlet is protected by a 20 Amp push–to–reset circuit breaker.

Figure 15 — 120 Volt AC, 20 Amp, Duplex Receptacle

Use each receptacle to operate 120 Volt AC, single–phase, 60 Hz electrical loads requiring up to 2,400 watts (2.4 kW) at 20 Amps of current. Use cord sets that are rated for 125 Volt AC loads at 20 Amps (or greater).

12 Volt DC, 10 Amp Receptacle

This receptacle allows you to recharge a 12 Volt automotive or utility style storage battery with the battery charge cables provided (Figure 16).

Figure 16 — 12 Volt DC, 10 Amp Receptacle

120 Volt AC, 20 Amp, Duplex

Receptacle

Each receptacle (Figure 15) is protected against overload by a 20 Amp push–to–reset circuit breaker.

This receptacle can not recharge 6 Volt batteries and can not be used to crank an engine having a discharged battery. See the section “Charging a Battery” (page 8) before attempting to recharge a battery.

11