Poulan XT8527ES, 96192002300 Loop Handle LH, Loop Handle RH, 405784X479 Pivot Support Weldment

Page 26

REPAIR PARTS SNOW THROWER - - MODEL NUMBER XT8527ES (96192002300)

HANDLES

3

3

	5	5	KEY	PART
		5	NO.	NO.	DESCRIPTION
			NO.	NO.	DESCRIPTION
	5		1	419798X479	LOOP HANDLE LH
		1	2	419799X479	LOOP HANDLE RH
	3		3	74780524	SCREW 5/16−18 X 1.50
	5		4	74780528	SCREW 5/16−18 X 1.75
	5		5	751153	NUT 5/16−18
			5	751153	NUT 5/16−18

4

2

01.08.004-A

1

4

3

4

4

01.05.002-B

KEY	PART	DESCRIPTION
NO.	NO.	DESCRIPTION

1419797X479 LOWER HANDLE

2405784X479 PIVOT SUPPORT WELDMENT

3150078 SCREW 5/16−18 X .750

417000616 SCREW 3/8−16 X 1.00

2

3

4

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 26

Image 26

Contents Model Number Snow ThrowerSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from CartonInstall Speed Control ROD See Figs Unfold Upper HandleCheck Tire Pressure Install Auger Control ROD See FigsInstall Discharge Chute / Chute Rotater Head See Fig Primer OperationKnow Your Snow Thrower Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting the engineHOW to USE Your Snow Thrower StoppingTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Throw Snow See Fig Before Starting the Engine To Start EngineIf Recoil Starter has Frozen Snow Throwing TipsBefore Stopping Before Each USE MaintenanceGeneral Recommendations LubricationCleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Storage OtherTroubleshooting Service Notes Exploded KEY Part Description Auger 27 LH Auger HousingScraper BAR Auger 27 RHAuger Bearing Bearing PlugDeflector Seal Chute WeldmentDeflector Weldment StrapRotator Pivot Bracket LEVER/CABLE Rotator AssemblyRotator Head Pulley Pivot405784X479 Pivot Support Weldment Loop Handle LHLoop Handle RH Knob RED SpacerRetainer Handle KnobShifter ROD TOP Impeller ROD AssemblyTraction ROD Assembly Shifter ROD BottomHeadlight Bezel Wire HarnessConsole Panel Flood HeadlightRepair Parts Snow Thrower - Model Number XT8527ES Drive Shoulder Screw Speed Selector AssemblyDrive Plate Assembly END PlateSprocket Axle ShaftRoll PIN 3/16 Clik PINKEY Part Description Engine Tecumseh Model LH318SA-156551H 417014X505 Engine Mount PlateImpeller Belt Belt CoverTraction Belt 187865X428 Wheel Assembly LH187833X428 35062 Safety Ignition KEYPart KEY Description DECAL, DANGER, Deflector 181037DECAL, Danger Service Notes Service Notes Limited Warranty