Simplicity LX 2900 manual Operation, Controls, Checks Before Starting, Operating On Slopes

OPERATION

Controls

Read and understand the instructions in your tractor Operator’s Manual.

Refer to Figure 1 for control locations.

A. ELECTRIC CHUTE ROTATOR

Rotates the chute right and left.

B. PTO SWITCH

Engages and disengages the snowthrower.

C. ATTACHMENT LIFT

Raises and lowers the snowthrower for transport.

D. PTO SELECTOR

Selects front, rear or both PTO’s. Select forward position for snowthrower use.

E. THROTTLE

Sets engine speed. Always use FULL throttle.

F. HYDRAULICS SELECTOR SWITCH

		Operation
E	A	C
G
		B
	F
		D

Figure 1. Controls
A. Electric Chute Rotator	E. Throttle
B. PTO Switch	F. Hydraulics Selector
C. Attachment Lift	G. Remote Deflector
D. PTO Selector	Control

Selects inboard or auxiliary hydraulics. Select forward position for snowthrower use.

G. REMOTE DEFLECTOR CONTROL

Sets and locks in the angle of the chute deflector.

Checks Before Starting

1.Refer to the Maintenance & Adjustments section of this manual and perform any needed service. Also, refer to the tractor Operator’s Manual and perform any required service.

2.Remove any objects from the work area which might be caught in, or thrown by, the auger.

3.Before starting the engine, clear the auger of any ice which may cause damage to the unit.

4.Adjust the deflector and skid shoes to desired height. See Skid Shoe Adjustment.

5.Make sure all hardware is present and secure.

Operating On Slopes

WARNING

•Never operate on slopes greater than 17.6%

(10°), which is a rise of 3-1/2 feet (106cm) verti- cally in 20 feet (607cm) horizontally.

•When operating on slopes wheel weights and tire chains are required.

•Select slow ground speed before driving onto a slope. Avoid using brakes to control speed.

•Drive up and down the face of the slopes, never across the slope face.

•Use caution when changing directions and DO NOT START OR STOP ON A SLOPE.

WARNING

Perform the Safety System Interlock test found in your tractor Operator’s Manual. If tractor does not pass the test, do not operate the tractor. See your authorized dealer. Under no circumstances should you attempt to defeat the safety system.

7