MTD 769-03250 warranty Safe Operation Practices, Training, Preparation, Your Responsibility

Page 4

2

Safe

Operation

WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm.

DANGER: This machine was built to be operated according to the safe operation practices in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

Practices

WARNING

This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol, HEED

ITS WARNING!

Your Responsibility

Restrict the use

of this power machine to persons who read, understand

and follow the warnings and instructions

in this manual

and on the machine.

Training

1.Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts.

2.Be familiar with all controls and their proper operation. Know how to stop the machine and disengage them quickly.

3.Never allow children under 14 years old to operate this machine. Children 14 years old and over should read and understand the instructions and safe operation practices in this manual and on the machine and be trained and supervised by an adult.

4.Never allow adults to operate this machine without proper instruction.

5.Thrown objects can cause serious personal injury. Plan your snow-throwing pattern to avoid discharge of material toward roads, bystanders and the like.

6.Keep bystanders, helpers, pets and children at least 75 feet from the machine while it is in operation. Stop machine if anyone enters the area.

7.Exercise caution to avoid slipping or falling, especially when operating in reverse.

Preparation

1.Thoroughly inspect the area where the equipment is to be used. Remove all doormats, newspapers, sleds, boards, wires and other foreign objects, which could be tripped over or thrown by the auger/impeller.

2.Always wear safety glasses or eye shields during operation and while performing an adjustment or repair to protect your eyes. Thrown objects which ricochet can cause serious injury to the eyes.

3.Do not operate without wearing adequate winter outer gar- ments. Do not wear jewelry, long scarves or other loose clothing, which could become entangled in moving parts. Wear footwear which will improve footing on slippery surfaces.

4.Use a grounded three-wire extension cord and receptacle for all units with electric start engines.

5.Adjust collector housing height to clear gravel or crushed rock surfaces.

6.Disengage all control levers before starting the engine.

7.Never attempt to make any adjustments while engine is running, except where specifically recommended in the operator’s manual.

8.Let engine and machine adjust to outdoor temperature before starting to clear snow.

Safe Handling of Gasoline

To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes, which can ignite. Wash your skin and change clothes immediately.

a.Use only an approved gasoline container.

b.Extinguish all cigarettes, cigars, pipes and other sources of ignition.

c.Never fuel machine indoors.

d.Never remove gas cap or add fuel while the engine is hot or running.

e.Allow engine to cool at least two minutes before refuel- ing.

f.Never over fill fuel tank. Fill tank to no more than ½ inch below bottom of filler neck to provide space for fuel expansion.

g.Replace gasoline cap and tighten securely.

h.If gasoline is spilled, wipe it off the engine and equip- ment. Move machine to another area. Wait 5 minutes before starting the engine.

i.Never store the machine or fuel container inside where there is an open flame, spark or pilot light (e.g. furnace, water heater, space heater, clothes dryer etc.).

j.Allow machine to cool at least 5 minutes before storing.

Image 4
Contents 769-03250 06/06/07Finding and Recording Model Number Table of ContentsCustomer Support Chute Clean-out Tool Your Responsibility Restrict the useSafe Operation Practices TrainingPreparation Your ResponsibilityMaintenance & Storage OperationDo not modify engine Average Useful LifeSetting Up Your Snow Thrower Housing Lamp Wiring Harness If equippedBehind handles until all moving Parts have stopped before unOperating Your Snow Thrower Know Your Snow Thrower$26% #/.42 Stopping The Engine Gas & Oil Fill-UpElectric Starter on certain models To Engage Drive To Engage AugersRecoil Starter Auger Control TestMaking Adjustments Chute Assembly optionalShift Cable Drive ControlTire Pressure Chute Bracket AdjustmentProperty Maintaining Your Snow Thrower EngineLubrication Shave Plate and Skid ShoesRoll the auger belt off the engine pulley. See Figure Auger Belt ReplacementUnhook the support bracket spring from the frame Drive Belt Replacement Remove and replace belt in the reverse orderFriction Wheel Removal Remove the rubber ring from between the platesOff-Season Storage Wipe equipment with an oiled rag to prevent rustTrouble Shooting Problem Cause RemedyYear Limited Warranty WarrantyAuger Housing COMPONENTS/COMPOSANTS DU Logement DES Tarières Manual Chute Control Part Description RÉF Pièce Optional/en option Part Description RÉF Pièce 30 in/po Remarque Lhabitacle peut être légèrement différentPart Description RÉF Pièce 31AE6GKF500 Part For parts and/or accessories refer to customer support on For parts and/or accessories refer to customer support on Page Garantie Propriétaire du l’intention àSolution Causes Problème DépannageSouffleuse Propre etCarburant le Videz Gaz ’entretien Régime Transmission De courroie la de RemplacementTarières ’entretien RégimeLubrification Patins et plate LameMoteur Réglages GoulotteLa de support du Ajustement PatinsOption en Goulotte Transmission la de CommandeVitesses de changement de Câble Avertissement Lanceur à Démarreur’huile et d’essence Pleins Modèles certains sur électrique DémarreurModèles Certains sur électrique DémarreurOption en tions Goulotte la de Commande Goulotte la de dégagement de OutilContact de Clé 33/-3.42! ,!.$% $%.!--#Souffleuse la de Commandes Goulotte la dégager De d’essayer avant immobiliséesSoient se pièces les toutes que Ce jusqu’à guidon le derrièreMontage de Instructions Remisage et Entretien Responsabilité VotreMoyenne utile vie de Durée Gaz de émissions les concernant AvisUtilisation PréparationFormation Responsabilité VotreSécurité de Étiquettes Est goulotte la de dégagement de outil UnVente-après Service Modèle de numéro le trouver PourMatières des Table ’utilisation La voir détachées PiècesAU Vente Aprés Service LE Appelez 03250-769