Auger Control
AUGER
CONTROL
GO
The auger control is located on the left handle. Squeeze the control grip against the handle to engage the augers and start snow throwing action. Release to stop.
Drive Control
DRIVE
CONTROL
GO
The drive control is located on the right handle. Squeeze the control grip against the handle to engage the wheel drive. Release to stop.
Chute Directional Control
CHUTE DIRECTIONAL CONTROL
|
| ADJUSTABLE |
DISCHARGE | DISCHARGE | CHUTE TILT |
LEFT | RIGHT |
|
The chute directional control is located on left side of the snow thrower.
To change the direction in which snow is thrown, turn chute directional control as follows:
•Crank clockwise to discharge to the left.
•Crank counterclockwise to discharge to the right.
Ignition Key
The ignition key is a safety devise. It must be fully inserted in order for the engine to start. Remove the ignition key when the snow thrower is not in use.
IMPORTANT: Do not turn the ignition key in an attempt to start the engine. Doing so may cause it to break.
Clean-Out Tool
WARNING: Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind handles until all moving parts have stopped before unclogging.
The chute
NOTE: This item is fastened with a cable tie to the rear of the auger housing at the factory. Cut the cable tie before operating the snow thrower.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust upward for
Recoil Starter Handle
The recoil starter handle is used to manually start the engine.
Electric Starter Button (If so equipped)
Pressing the electric starter button engages the engine’s electric starter when plugged into a 120V power source.
Electric Starter Outlet (If so equipped)
Requires use of a
Augers
When engaged, the augers rotate and draw snow into the housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute assembly.
9