Simplicity 1693164 755M, 1693426 755E Safety Signs & Decals, Safety Decals, Additional Decals

Page 8

Safety Signs & Decals

SAFETY DECALS

Safety warning decals are placed at strategic locations on the snowthrower as a constant reminder to the opera- tor of the most important safety precautions. All warning, caution and instructional messages on your snowthrow- er should be carefully read and obeyed. If any of these decals are lost or damaged, replace them at once. They can be purchased from your local dealer.

WARNING

TO AVOID SERIOUS INJURY

Read Owner’s Manual before operating unit.

Never allow children to operate snowthrower.

Always direct discharge chute so as to avoid injury

to persons—or damage to property

Stop engine and disconnect spark plug wire before removing debris or servicing unit.

• Keep all shields and guards in place while running.

Part No. 1715556

WARNING / Main Dash Decal

Part No. 1715555

Auger Control Decal

DANGER

AVOID INJURY

FROM ROTATING

BLOWER!

Shut off engine before unclogging discharge chute.

1716533

Part No. 1716533

Discharge Chute Danger Decal

DANGER

AVOID INJURY

FROM ROTATING

AUGER!

Keep hands, feet, and clothing away.

1716532

Part No. 1716532

Auger Danger Decal

Engine "Hot" Decal

Decal supplied by the engine manufacturer.

See your local Tecumseh dealer.

ADDITIONAL DECALS

Additional decals used on this unit are also available, and may be desired as replacement parts to maintain the performance and value of your unit. These can also be purchased from your local dealer.

Part No. 1715558

Simplicity Logo Decal

SNO-AWAY7

55cm

Part No. 1714107 (755) Or Part No. 1714108 (555)

Simplicity Logo Auger Decal

Part No. 1715557

Speed Selector Decal

TOUCH-UP PAINT PART NUMBERS

13 Oz. Spray Can Paint

 

Deep Orange

1685611

Gloss Black

1685639

1/2 Oz. Touch-Up Bottle

 

Deep Orange

1685615

Part No. 1709061

Touch-Up Paint ID Decal

4

Image 8
Contents How to use this file...Operators Manuals Simplicity Technical Publications Department at 414This page Intentionally Blank OPERATOR’S Manual ModelsPage Table Of Contents Preparation Safety RulesGeneral Maintenance & Storage OperationAdditional Decals Safety Signs & DecalsSafety Decals Engine Controls Control Reference ChartSnowthrower Controls Controls Starting ControlsElectric Start Units Only Manual StartGround Speed Controls Auger ControlDeflector Controls Scraper Height ControlOperation Checks Before Each START-UPStarting the Engine Operating the SnowthrowerEngine Speed Ground Speed SelectorDeflector Scraper BAR & Skid ShoesFREE-WHEELING Traction Drive Lock After Each USEKlik-Pin Outer Hole Klik-Pin Inner HoleRegular Maintenance Normal CareOFF-SEASON Storage Starting After StorageLubrication Drive Disc Friction DiscService TroubleshootingEngine fails to start Engine starts hard or runs poorlyScraper bar does not clean hard Auger does not stop when augerAuger rotates, but snow is not Thrown far enoughSpeed Selector Pivot ADJUST- Ment Traction Drive Clutch ROD AdjustmentInitial Adjustment Run-In AdjustmentRelease Auger Control. Auger must stop within 5 seconds Auger Drive Clutch ROD AdjustmentDrive Belt Adjustment Auger Control Belt Cover Checking Auger Belt & Belt Guide AdjustmentsAdjusting Auger Drive Belt Drive Belts and Replacement Adjusting Auger Belt GuideTraction Drive Belt Replacement Traction Drive Belt & PulleyAuger Drive Belt Replacement Auger Drive Pulley Auger Belt StopsRoller Chain Replacement Shear PIN ReplacementShear Pins Keeper linkDischarge Chute Worm Assembly Adjustment Discharge Chute Worm Assembly Adjustment ScrewChecking Tire Pressure Mounting ScrewsAuger Housing Overall Dimensions & WeightEngine DriveTechnical Manual Availability Common Replacement PartsAccessories