Simplicity 1694583 319M, 1694584 319E instruction sheet Troubleshooting, Adjustments, & Service

Page 19
Troubleshooting, Adjustments, & Service

Troubleshooting, Adjustments, & Service

AUGER DRIVE BELT IDLER PULLEY ADJUSTMENT

If the auger control cable has run out of adjustment, the drive belt idler pulley (B) can be adjusted to take up more belt slack.

1.Turn the engine OFF.

2.Loosen the jam nut (B, Figure 5) at the upper end of the cable. Hold the threaded end of the cable and turn the cable counterclockwise until the adjustment is half way between fully in and fully out.

3.Remove the belt cover to access the idler pulley (B, Figure 7).

4.Loosen the idler capscrew (C) and slide the idler pul- ley (B) to the back of the slot in the idler bracket (A).

5.Retighten the capscrew (C) and perform the AUGER CONTROL ADJUSTMENT.

After performing the AUGER CONTROL ADJUST- MENT reinstall the belt cover.

AUGER DRIVE BELT IDLER PULLEY ADJUSTMENTManual background WARNING

DO NOT over-tighten the cable. The control cable must have some slack in the disengaged position for the auger brake to function properly. If the auger does not stop within 5 seconds of the auger control being released, see your dealer.

A

B

D

C

O

F

F

F

F

O

Figure 7. Auger Drive Belt Idler Pulley Adjustment

A.Idler Pulley Bracket

B.Idler Pulley

C.Idler Pulley Capscrew

D.Cover Studs

15

Image 19
Contents Press Print Vendor InstructionsOperator’s Manuals Paper SizeTHIS PAGE INTENTIONALLY BLANK FOR PLACEMENT ONLY - DO NOT PRINT Single Stage Snowthrower 319M Models319E Models OPERATOR’S MANUALPage Troubleshooting, Adjustments, & Service Table of ContentsSafety Rules & Information Regular MaintenanceOPERATION Safety Rules & InformationTRAINING PREPARATIONCLEARING A CLOGGED DISCHARGE CHUTE Safety RulesSERVICE, MAINTENANCE, AND STORAGE CHILDRENREFERENCE DATA IDENTIFICATION NUMBERSID Tag PRODUCTSAFETY DECALS Safety Decals / Identification NumbersCONTROL LOCATIONS Features ControlsChute Direction Control Features & ControlsIgnition Switch Chute Deflector ControlDANGER Discharge Chute AdjustmentOperation GENERAL OPERATIONOperation PROPER FUEL MIXING PROCEDUREFUEL AND OIL MIXTURE STOPPING THE ENGINE STARTING THE ENGINEAfter Each Use OPERATING THE SNOWTHROWERSNOWTHROWING TIPS STORAGECHECK AUGER CABLE & STOPPING TIME Regular MaintenanceMAINTENANCE SCHEDULE ENGINE / SEASONAL MAINTENANCEPROBABLE CAUSE Troubleshooting Adjustments, & ServiceTROUBLESHOOTING PROBLEMInspection Troubleshooting, Adjustments, & ServiceAUGER CONTROL ADJUSTMENT AdjustmentAUGER DRIVE BELT IDLER PULLEY ADJUSTMENT Troubleshooting, Adjustments, & ServiceAUGER DRIVE BELT REPLACEMENT AUGER FLITE SHOE REPLACEMENT TECHNICAL MANUALS SPECIFICATIONSREPLACEMENT PARTS MAINTENANCE ITEMS