
Traction Control / Auger Control Lock
The cams on the ends of the control rods which interlock the traction drive and auger drive controls must be lubricated at least once a season or every 25 hours of operation. The cams can be accessed beneath the handle panel. Use a
Drive and Shifting Mechanism
Lubricate at least once a season or after every 25 hours of operation. Remove the rear cover, lubricate any
chains, sprockets, gears, bearings, shafts, and shifting mechanism at least once a season. Use engine oil or a spray lubricant. Avoid getting oil on the friction wheel rubber and aluminum drive plate. Refer to Figure 9.
There is a grease fitting on the top of the axle shaft which drives the rear track drive wheels on both sides of the unit. Grease these fittings every 25 hours or once a season.
SECTION 7: SERVICING YOUR SNOW THROWER
WARNING: Before servicing, repairing, or inspecting, disengage all clutch levers and stop engine. Wait until all moving parts have come to a complete stop. Disconnect spark plug wire and ground it against the engine to prevent unintended starting.
Engine
Refer to the separate engine manual packed with your unit for all engine maintenance procedures.
Augers
•The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign object or ice jam, the snow thrower is designed so that the bolts may shear.
Refer to Figure 14.
•If the augers will not turn, check to see if the bolts have sheared. Replacement shear bolts and hex lock nuts have been provided with the snow thrower. When replacing bolts, spray an oil lubricant into shaft before inserting new bolts.
IMPORTANT:NEVER replace the auger shear bolts with standard hex bolts. Any damage to the auger gearbox or other components as a result of doing so will NOT be covered by your snow thrower’s warranty.
Shave Plate and Skid Shoes
•The shave plate and skid shoes on the bottom of the snow thrower are subject to wear. They should be checked periodically and replaced when necessary.
•To remove skid shoes, remove the four carriage bolts, cupped washers and hex nuts which attach them to the snow thrower. Reassemble new skid shoes with the four carriage bolts, cupped washers (cupped side goes against skid shoes) and hex nuts. See Figure 15.
Skid Shoe | Carriage |
|
| Bolts |
|
| Shave Plate |
|
| Skid Shoe | Hex Nuts |
Figure 15
Belt Removal And Replacement
Auger Belts
NOTE: It is necessary to remove both belts in order to change either one. If changing just one belt, be certain to check the condition of the other belt.
•Remove the plastic belt cover at the front of the engine by removing the two
Screw |
Belt Cover |
Figure 16
13