Snapper EI7243 Engaging Auger, Engaging Wheel Drive, Stopping ENGINE, Auger & Wheel Drive

Page 9

Section 2 - OPERATING INSTRUCTIONS

WARNING

Objects can be thrown by the snow thrower while it is in operation. Thrown objects could cause serious injury to the operator or bystanders. Always wear safety goggles or other suitable eye protection. Keep people and pets away from area.

2.2.3. ENGAGING AUGER

1.Move auger control lever against handle to engage auger. See Figure 2.6.

2.2.4. ENGAGING WHEEL DRIVE

1.Move wheel drive control lever against handle to engage wheel drive. See Figure 2.6. Ground speed can be changed while the machine is in operation by changing position of the ground speed control. IMPORTANT: This snow thrower has four forward speeds and one reverse speed. See Figure 2.5.

MOVE WHEEL DRIVE

MOVE AUGER

CONTROL AGAINST

CONTROL AGAINST

HANDLE TO ENGAGE

HANDLE TO

WHEEL DRIVE

ENGAGE AUGER

ROTATE CHUTE

CRANK TO CHANGE

DIRECTION OF

DISCHARGE CHUTE

FIGURE 2.6

WARNING

Release auger clutch and wheel drive controls and make sure auger/impeller and wheel drive have STOPPED before rotating discharge chute, adjusting deflector, or placing hands near auger/impeller.

2.2.5.DISCHARGE CHUTE and DEFLECTOR ADJUSTMENT

1.Release auger control and wheel drive control levers to allow auger and ground speed to come to a complete stop. See Figure 2.6.

2.Loosen deflector knob and position deflector to desired angle. Retighten knob.

3.Rotate chute crank to position discharge chute in desired direction. See Figure 2.6.

2.2.6.STOPPING - ENGINE, AUGER & WHEEL DRIVE

Stop the auger and wheel drive by releasing the auger and wheel drive control levers. See Figure

2.6.Stop the engine by removing the key from the switch or moving engine speed control to the STOP position. Always remove key from key switch before leaving machine unattended. See Figure 2.7.

MOVE ENGINE

SPEED CONTROL

TO “STOP”

POSITION TO STOP

ENGINE

REMOVE KEY TO

STOP ENGINE

FIGURE 2.7

9

Image 9
Contents Model Number Explanation Model Designation Series Designation Engine HP Auger WidthInstruction No -3334 I.R /14/00 Operational Precautions Protection for ChildrenPreparation Maintenance and Storage Table of Contents Year of Manufacture European Community DecalsHearing Protection Required Safety Instructions to Prevent InjuryPRE-START Check List Minimum Gauge for Cord SetsGo to Page 10 for Electric Start Models 2.2.1. Engine STARTING, Operation & Stopping Recoil Start ModelsEngaging Auger Engaging Wheel DriveStopping ENGINE, Auger & Wheel Drive STARTING, Operation & Stopping Electric Start Models Operating Instructions Introduction Service After First 5 Hours Check Auger Drive BeltCheck Wheel Drive Belt General LubricationStorage Procedure Annually END of Each SeasonEngine Spark Plug Auger Belt Adjustment Idler Pulley Adjustment Repair & AdjustmentsAuger Belt Replacement Repair & Adjustments Ground Speed Adjustment Skid Shoe Adjustment1st 4th Single Handle Control Adjustment 7 HP Models Only Rubber Drive Disc Replacement Chute Crank AdjustmentService Performed Each Problem Probable Cause Corrective Action100 USE HRS SeasonDisclaimer of Warranty Year Limited WarrantyPage Page European TWO Stage Intermediate Frame Snow Thrower Series
Related manuals
Manual 24 pages 40.8 Kb