Dealer Setup
& Adjustment Instructions
520 Series Single Stage Snowthrower
This Dealer Setup Instruction applies to the following units:
These instructions may cover additional models issued after their printing. Refer to the Dealer Setup Binder Index for complete listings.
520 Series Snowthrowers
Mfg. No. Description
7085663 SS5201R, 5HP Snowthrower, Manual Start
7085664 SS5201E, 5HP Snowthrower, Electric Start
1694585 5201M, 5HP Snowthrower, Manual Start
1694586 5201E, 5HP Snowthrower, Electric Start
ATTENTION SETUP PERSONNEL:
The safety warnings provided in this guide and in the operator's manual included with the unit contain important information that
must be obeyed when assembling,
These warnings are highlighted by the safety alert tri- angle symbol shown above, which signifies that an important safety message is being provided.
You must read, understand, and follow these warn- ings and instructions, and use safe shop and work practices at all times while working on or around this unit and all other outdoor power equipment.
Sections and items denoted by the Setup
symbol provide the information necessary to fully assemble, test, and prepare the units
described above for delivery to your customers.
A Quick Setup List is provided on page 3 of this booklet to help you identify and check that the items have been performed.
TABLE OF CONTENTS: |
|
SAFETY RULES | 2 |
SETUP PROCEDURES |
|
Quick Setup List | 3 |
Unboxing and Assembly | 4 |
Fill Gas Tank | 5 |
Fuel Oil Mix | 5 |
Proper Fuel Mixing Procedure | 5 |
Lubricate the Snowthrower | 6 |
Removing the Belt Cover | 6 |
Lubrication Points | 6 |
Test Run | 7 |
ADJUSTMENT PROCEDURES |
|
Removing Engine Cover | 8 |
Carburetor Adjustment | 8 |
Servicing the Spark Plug | 8 |
Auger Control Cable Adjustment | 9 |
Checking the Adjustment | 9 |
Adjusting the Cable | 9 |
Testing the Auger Control Cable | 9 |
Replacing the Drive Belt | 10 |
Replacing the Scraper Blade | 10 |
|
| Manual No. 7100193 |
5/2005 | 1 | I.R. 6/10/2005 |
TP |