Snapper 8246, 9266E, 11306, 9266 important safety instructions Skid Shoe Adjustment

Page 16

Section 4 - REPAIR & ADJUSTMENTS

4.1.5. SKID SHOE ADJUSTMENT

NOTE: It is recommended to raise the auger/impeller housing when clearing rough or graveled surfaces. To raise auger/impeller the skid shoes should be lowered.

1.Tilt machine up and place a wooden block under auger/impeller housing.

2.Loosen bolts on both skid shoes. Move shoes down to raise auger/impeller housing or move skid shoes up to lower auger/impeller housing. See Figure

SCRAPER BLADE

			SKID
			SHOE
	SKID	BLOCK	LOOSEN CARRIAGE
	SHOE	BLOCK	BOLTS TO SHIFT
	SHOE		BOLTS TO SHIFT

SCRAPER BLADE

UP FOR SMOOTH, PAVED SURFACES

DOWN FOR ROUGH, GRAVELED SURFACES

FIGURE 4.8

16

Image 16

Contents Engine HP Electric Start Auger Width Series Designation Model Number ExplanationManual No -4333 I.R /23/01 Protection for Children Operational PrecautionsPreparation Maintenance and Storage Table of Contents Introduction NomenclatureMinimum Gauge for Cord Sets PRE-START Check ListSTARTING, Operation & Stopping Recoil Start Models Go to Page 9 for Electric Start Models EngineEngaging Auger Discharge Chute and Deflector AdjustmentEngaging Wheel Drive STARTING, Operation & Stopping Electric Start Models Stopping ENGINE, Auger & Wheel Drive Free Wheel MachineService After First 5 Hours Check Auger Drive Belt General LubricationGear CASE, Auger Shaft and Auger Bearing Lubrication Check Wheel Drive BeltStorage Procedure Maintenance and Service PartsAnnually END of Each Season Engine Spark PlugAuger and Wheel Drive Cable Adjustment Auger Belt Idler Pulley AdjustmentRecheck cable for proper extension 3/8 Reinstall belt cover Repair & Adjustments Skid Shoe Adjustment Single Handle Control Adjustment Chute Crank Adjustment Rubber Drive Tire ReplacementProblem Probable Cause Corrective Action Service Performed Each100 USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPage Page Page TWO Stage Large Frame Snow Thrower Series Instruction No -4333 I.R /23/01