Poulan 187881 Assembly / Pre-Operation, INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD See Fig

Page 7

INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD (See Fig. 7)

ASSEMBLY / PRE-OPERATION

INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD (See Fig. 7)

NOTE: The multi-wrench provided in your parts bag may be used to install the chute rotater head.

1.Place discharge chute assembly on top of chute base with discharge opening toward front of snow thrower.

2.Position chute rotater head over chute bracket. If nec- essary, rotate chute assembly to align square and pin on underside of chute rotater head with holes in chute bracket.

3.With chute rotater head and chute bracket aligned, position chute rotater head on pin and threaded stud of mounting bracket.

4.Install 3/8 washer and locknut on threaded stud and tighten securely.

CHUTE
ROTATER
HEAD	3/8 LOCKNUT
	3/8 WASHER

CHUTE

BRACKET

PIN

THREADED

STUD

ROTATER HEAD

MOUNTING

BRACKET

FIG. 7

CHECK TIRE PRESSURE

The tires on your snow thrower were overinﬂ ated at the fac- tory for shipping purposes. Correct and equal tire pressure is important for best snow throwing performance.

•Reduce tire pressure to 14-17 PSI.

7

Image 7

Contents Do Not Throw Away SNOW THROWERIMPORTANT MANUAL PP5524ESBPREPARATION SAFETY RULESSafe Operation Practices for Snow Throwers TRAININGPRODUCT SPECIFICATIONS MAINTENANCE AND STORAGECUSTOMER RESPONSIBILITIES PRODUCT SPECIFICATIONS PARTS PACKED SEPARATELY IN CARTONSERVICE AND ADJUSTMENTS SAFETY RULESINSTALL SPEED CONTROL ROD See Figs. 1 and ASSEMBLY / PRE-OPERATIONHOW TO SET UP YOUR SNOW THROWER REMOVE SNOW THROWER FROM CARTONINSTALL AUGER CONTROL ROD See Figs. 5 and INSTALL TRACTION DRIVE CONTROL ROD See Figs. 3 andCHECK TIRE PRESSURE INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD See FigKNOW YOUR SNOW THROWER OPERATIONRecoil auxiliary starter handle - used for starting the engine MEETS A.N.S.I. SAFETY REQUIREMENTSTO USE FUEL SHUT-OFF VALVE See Fig HOW TO USE YOUR SNOW THROWERTO USE CHOKE CONTROL See Fig STOPPINGAUGER CONTROL LEVER TO THROW SNOW See FigTO MOVE FORWARD AND BACKWARD See Fig HIGH POSITION KNOB CHUTE DEFLECTOR LOW POSITIONCHECK ENGINE OIL LEVEL See Fig BEFORE STARTING THE ENGINETO ADJUST SKID PLATES See Fig SCRAPER BARBEFORE STOPPING SNOW THROWING TIPSIF RECOIL STARTER HAS FROZEN LUBRICATION MAINTENANCEGENERAL RECOMMENDATIONS BEFORE EACH USEAUGER GEAR CASE CLEANINGENGINE V-BELTSCHUTE DEFLECTOR SERVICE AND ADJUSTMENTS1. Be sure throttle is in STOP position 2. Remove safety ignition key TO ADJUST SNOW THROWER HEIGHTTO REPLACE BELTS See Fig CARBURETOR STORAGEOTHER TO REMOVE WHEELS See FigEngine idles or TROUBLESHOOTINGLoss of power Does not startLIMITED WARRANTY