Poulan 185136 owner manual Meets A.N.S.I. Safety Requirements

OPERATION

SPARK	ENGINE OIL CAP	AUGER	DISCHARGE CHUTE CONTROL LEVER
PLUG	WITH DIPSTICK	CONTROL
SAFETY		LEVER	DRIVE SPEED	DEFLECTOR REMOTE
IGNITION
			CONTROL LEVER	CONTROL LEVER
KEY	GASOLINE
	FILLER
	CAP			TRACTION
CHOKE		CHUTE
				DRIVE
	DEFLECTOR
CON-				CONTROL
TROL				LEVER

THROTTLE /				LH TURN
ENGINE				TRIGGER
CONTROL
			OIL DRAIN
			PLUG	LIGHT
RECOIL	POWER
(AUXILIARY)
	CORD
STARTER	PLUG	ELECTRIC
HANDLE
		START	FUEL SHUT-OFF VALVE	HANDLE
		BUTTON		KNOB
			DISCHARGE
PRIMER
			CHUTE
				MUFFLER
NOTE: ITEMS ABOVE				TOOLBOX
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.

SKID PLATE

AUGER

FIG. 11

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox - used to store spare shear bolts, locknuts and wrench.

Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button - used for starting the engine.

Recoil (auxiliary) starter handle - used for starting the engine.

Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.

Choke Control - used for starting a cold engine.

Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.

LH and RH turn triggers - used to steer the snow thrower.

Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw snow).

Discharge chute control lever - used to change the di- rection the snow is thrown.

Deflector remote control lever - used to change the distance the snow is thrown.

Skid plate - used to adjust height of scraper bar from the

9 ground.