Simplicity 1693166, 1692984, 1692986, 1692992 Fuel and OIL Mixture, Proper Fuel Mixing Procedure

Page 13

FUEL AND OIL MIXTURE

The snowthrower uses a two cycle engine that requires a mixture of fuel (gasoline) and oil for lubrication of engine bearings and other moving parts.

The correct fuel/oil mixture ratio for the five horsepower engine is 50 to 1. Use fuel/oil mixture chart shown.

NOTE: To prevent damage to engine, carefully observe recommended fuel to oil mixing ratio and procedures.

Gasoline and oil must be premixed in a clean fuel container.

Always use fresh, unleaded, winter grade fuel

Never put plain, unmixed fuel into fuel tank. Shake fuel container each time before filling fuel tank.

Never use “stale” fuel left over from last season or stored for long periods.

DO NOT USE MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.

Controls & Operation

FUEL TO OIL MIXTURE CHART (50:1)

U.S.

Imperial

Metric

Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil Gasoline 2 Cycle Oil

Gallons

Ounces

Gallons

Ounces

Liters

Milliliters

1

2.5

1

2.8

4

80 ml

2

5

2

5.6

8

160 ml

5

13

5

14.1

20

400 ml

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is hot or running. Always move outdoors to fill the tank. Keep snowthrower and gasoline away from open flame or spark.

PROPER FUEL MIXING PROCEDURE

1.Fill approved clean fuel container one quarter full with fresh unleaded fuel - one quart (one liter) in a one gallon (4 liter) container.

2.Pour recommended amount of high quality two cycle oil — 2.5 ounces (80 ml) into fuel container for one gallon (4 liters) of fuel. (NOTE: DO NOT USE

MULTI VISCOSITY OILS, SUCH AS 10W-30 or 10W-40.)

3.Reinstall cap on the fuel container and shake con- tainer vigorously so oil mixes with gasoline.

4.Unscrew cap and fill container with fuel. Shake con- tainer again.

5.Remove fuel tank cap and carefully pour mixed fuel into the fuel tank, filling to 1/2 inch (1.5 cm) below filler neck to allow room for expansion. Never put plain, unmixed fuel into fuel tank. Shake fuel con- tainer each time before filling fuel tank.

A BCD

Figure 6. Proper Fuel Mixing Procedure

A.Fill Container with 1 Quart (1 Liter) of fuel

B.2.5 Ounces (80 ml) of two-cycle oil

C.Combine in container, then shake container

D.Additional fuel brings total to 1 Gallon (4 liters)

9

Image 13
Contents Print Vendors Paper Manuals How to use this file...Operators ManualsThis page Intentionally Blank OPERATOR’S Manual Page Table of Contents Preparation GeneralOperation Safety Rules & InformationSafety Decals International SymbolsDischarge Chute Danger Decal Auger Danger DecalTools Required Assembly ProcedureAuger Control Snowthrower ControlsDeflector Controls Engine & Starting Controls Controls & OperationElectric Start Units Only All ModelsChecks Before Each START-UP General OperationFuel and OIL Mixture Proper Fuel Mixing ProcedureMulti Viscosity OILS, Such AS 10W-30 or 10W-40 Stopping the Engine Starting the EngineElectric Starting Steps Manual Recoil Starting StepsSnowthrowing Tips Operating the SnowthrowerAfter Each USE OFF-SEASON StorageLubrication Removing Belt CoverEngine Lubrication Remove and/or loosen Cover Screws Removing Engine CoverAuger Control Cable Adjustment Troubleshooting & ServiceCarburetor Adjustment Replacing the Scraper Blade Replacing the Drive BeltServicing the Spark Plug Cleaner/Polish/Protectant Equipment Cleaner/Degreaser/DegrimerTechnical Manuals Additional Technical Literature Available