Skid | Hex Nuts |
Shoes |
Figure 7
•Retighten the hex nuts loosened earlier.
•Repeat this adjustment on the skid shoe found on the opposite side of the snow thrower.
Tire Pressure
The tires are overinflated for shipping purposes.
•Check tire pressure, by referring to tire sidewalls for recommended tire pressure.
NOTE: If the tire pressure is not equal in all tires, the unit may pull to one side or the other.
WARNING: Maximum tire pressure under any circumstance is 30 psi. Equal tire pressure should be maintained at all times. Excessive pressure (over 30 psi) when seating beads may cause tire/rim assembly to burst with force sufficient to cause serious injury.
SECTION 3: KNOW YOUR SNOW THROWER
Traction Control / |
|
|
|
|
|
|
| Shift Lever |
|
|
Auger Control Lock |
|
|
|
|
|
|
| Chute Tilt | ||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| |||
Headlight |
|
|
|
|
|
|
| Control | ||
|
|
|
|
|
|
| Auger Drive Control | |||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| ||||
Discharge Chute 
Auger
| Trigger Lever |
| Closed |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
| Open |
|
|
|
|
|
|
|
| Electric | ||
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Electric Chute | Primer |
|
|
|
|
|
|
|
|
|
|
|
| Starter |
| Rotation Switch |
|
|
|
|
|
|
|
|
|
|
|
| Button | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
| Choke |
|
|
|
|
|
|
|
|
|
|
|
| Switch |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Box | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| Safety |
|
|
|
|
|
|
|
|
|
|
|
| Recoil |
|
|
|
|
|
|
| |||||||||
Skid Shoe |
| Ignition Key |
|
|
|
|
|
|
|
|
|
|
| Starter | |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Handle | |
|
|
| Throttle |
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
| Control |
|
|
|
|
|
|
|
| ||||
Figure 8
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
Traction Control / Auger Control Lock
The traction control is located on the right handle. Squeeze the traction control to engage the wheel drive. Release to stop. See Figure 8.
This same lever also locks the auger control to avoid interruption of the snow throwing process. If the auger control is engaged along with the traction control, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release the traction control to stop both the augers and wheel drive (auger control must also be released).
IMPORTANT: Always release tractional control before changing speeds.
7