Yard-Man 31AE993J401 manual Chute Crank, Chute Tilt Control, Discharge Chute, Skid Shoe, Headlight

Page 8

IMPORTANT: Always release traction the control before changing speeds.

Forward

Your snow thrower has six forward (F) speeds. Position number one (1) is the slowest and position number six

(6)is the fastest.

Reverse

Your snow thrower has two reverse (R) speeds. R1 is the slower, while R2 is the faster of the two.

Chute Crank

The chute crank is located on the left hand side of the snow thrower. To change the direction in which snow is thrown, turn the chute crank as follows:

Turn clockwise to discharge to the left;

Turn counterclockwise to discharge to the right.

Chute Tilt Control

The distance snow is thrown can be changed by adjusting the angle of the chute assembly. Move the chute tilt control forward to decrease the distance, toward the rear to increase. See Figure 9.

Discharge Chute

The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; tilt down for less distance.

Skid Shoe

The position of the skid shoe is determined by the condition of the ground from where snow has to be removed.

Wheel Steering Controls

The left and right wheel steering controls are located on the underside of the handles and are used to assist in steering the snow thrower. See Figure 9.

Squeeze the right wheel steering control when turning right; squeeze the left control when turning left.

Operate the snow thrower in open areas until becoming familiar with these controls.

Headlight

The headlight is on whenever the engine is running.

Throttle Control

The throttle control is located on the engine. It regulates the speed of the engine.

Safety Ignition Key

The safety ignition key must be fully inserted in the switch before the unit will start. Remove key when snow thrower is not in use. Do not attempt to turn the key.

Traction Control /

Shift Lever

 

Auger Control Lock

 

Headlight

Auger Drive Control

 

Fuel Tank

 

Chute Tilt

 

Discharge

 

Control

 

Chute

 

 

 

 

Chute Crank

 

 

Wheel Steering

 

 

Control

Electric

 

 

 

Primer

Starter

 

Button

 

 

 

Choke

Switch

 

Box

 

 

Auger

Safety

Recoil

 

Ignition Key

Starter

Skid Shoe

Throttle

Handle

 

Control

 

Figure 9

8

Image 8
Contents OPERATOR’S Manual Table of Contents Important Safe Operation Practices TrainingPreparation OperationMaintenance And Storage Assembling Your Snow Thrower UnpackingLoose Parts Assembling HandleAuger Control Final AdjustmentsTraction Control and Shift Lever Knowing Your Snow Thrower Auger ControlShift Lever Skid ShoesSafety Ignition Key Chute CrankChute Tilt Control Discharge ChuteOperating Your Snow Thrower Before Starting Gas And Oil Fill-upTo Start Engine Electric StarterTo Stop Engine To Engage Wheel DriveTo Engage Augers Operating TipsMaintaining Your Snow Thrower Carburetor LubricationShave Plate and Skid Shoes Servicing Your Snow ThrowerAugers Replacing Belts Auger BeltChanging Friction Wheel Rubber Drive BeltEngine Off-season StorageTroubleshooting Problem Cause RemedyModel 31AE993J401 Model 31AE993J401 Part Description15 48 Yard-Man Green Yard-Man Yellow Powder Black Model 31AE993J401 Yard-Man Green Yard-Man Yellow Powder Black Model 31AE993J401 Description Handle Suppt. Bracket 5/8 RH Page Page MANUFACTURER’S Limited Warranty for