Briggs & Stratton 1738, 1732, 1628, 1524 manual Service, Tion Drive Tension

Page 32

Service

6.Reverse the procedure to install the belts. Be sure there are no twists and the belts are properly seated in the grooves. Adjust the belt stops so there is 1/8” (3mm) clearance between belt and stop. The pattern for both belts is shown in Figure 30. Slide the right axle left fully before tightening the set collar (E, Figure 29).

7.Check the traction drive tension and auger drive ten- sion. Follow the procedures under AUGER/TRAC-

TION DRIVE TENSION.

8.Make sure the auger stops when the auger drive lever is released. Make sure traction drive stops when the traction drive lever is released. If not, check the drive tension. If a problem exists, see your dealer.

	E
D	C
	C
B	B
A	A

Figure 29. Auger Pulley Belt Stops (shown with bottom cover removed)

A.Nuts

B.Belt Stops

C.Auger Pulley

D.Gear Assembly Bolts

E.Set Collar

E

E

C

D

A

B

F

F

Figure 30. Belt Pattern (viewed from front)

A.Engine Pulley

B.Drive Belt

C.Idler Pulley

D.Driven Pulley

E.Engine Belt Stops

F.Auger Pulley Belt Stops (Power Boost Units Only)

30

Image 32

Contents OPERATOR’S Manual ModelsPage Table of Contents Safety Rules & Information Operating SafetySafety Rules & Information Moving PartsTraining Ignition System Page Decals DecalsNorth American Model Decals CE Model DecalsDecals and Safety Icons Safety IconsALL Model Decals Shift Decal leftIdentification Numbers CE Identification TAG MarkingsNorth American CE ModelsManual Rotator Electric Model Features, Controls & OperationControl Locations Features & Controls Operation Checks Before Each START-UPStarting Controls Electric StartManual Start Snow Series MaxStarting the Engine Stopping the Engine Operating the Snowthrower Clearing a Clogged Discharge ChuteGround Speed Selector Engine SpeedDeflector Scraper BAR & Skid ShoesModels with Chute Deflector Knob Models with Remote Deflector ControlFull Traction Easy Turn Traction Easy Turn Freewheeling and Traction Drive LockStorage StorageAfter Each USE Regular Maintenance Maintenance ScheduleChecking Tire Pressure Auger Gear Case LubricationRegular Maintenance LubricationLubricate as shown in Figures Lubricate Auger Shaft AssemblyCheck / Lubricate FREE-HAND Linkage Problem Possible Cause Remedy Troubleshooting, Adjustments & ServiceTroubleshooting Troubleshooting Adjustments Speed Selector AdjustmentAuger Drive Tension Release auger control. Auger must stop within 5 secondsTraction Drive Tension Initial AdjustmentRun-In Adjustment Gear Bracket Adjustment Manual Discharge Chute Control Linkage AdjustmentPinion Gear Adjustment Shear PIN Replacement Adjustments & ServiceEasy Turn Cable Adjustment Belt Replacement Belt Cover ScrewsService Tion Drive TensionSpecifications DimensionsEngine ChassisParts & Accessories Replacement PartsMaintenance Items Technical Manuals