Briggs & Stratton 1687228, 1687227 installation instructions Installation Instructions

Installation Instructions

Gear Case Kit

Part No. 1687227 & 1687228

For 2004 Simplicity 860EI Intermediate Snowthrowers

1694433, 1694434

Kit Contents:

	Ref	Part No.	Qty.	Description
4	1	1721684	1	GEAR CASE, RH
3	2	7090052	6	WASHER, 1/4” SPLIT LOCK
	3	7092129	12	WASHER, FLAT, .268 x .591
	4	7091576	6	NUT, HEX, 1/4-20
	5	7092125	6	SCREW, HEX, 1/4-20 x 7/8
	6	1721676	1	GASKET, GEAR CASE
2	7	1721685	1	GEAR CASE, LH
7	8	960625	1	FITTING - PIPE PLUG
	8
	6
	1
	3
	5

Figure 1. Contents

This kit is to service intermediate snowthrowers.

INSTALLATION

Disassemble Housing

WARNING

Before beginning any service work turn off the ignition, and disconnect the spark plug wire(s).

1.Remove the washers and retaining rings (D, Figure 2) from both ends of the auger shaft. Remove the bearings (C).

2.Remove the hardware securing both side covers (A), and remove the side covers.

A

D

B

C

Figure 2. Disassemble Housing

A.Side Cover

B.Housing

C.Bearing

D.Washers & Retaining Ring

1