Electric Chute-Rotation Switch
The electric
To change the direction in which discharged snow is thrown, proceed as follows:
•Push the toggle switch to the left to rotate the chute counterclockwise.
•Push the toggle switch to the right to rotate the chute clockwise.
IMPORTANT: Release the switch once the chute has completed its rotation cycle in either direction. Failure to do so can result in damage to the electric chute motor and/or its drive gear.
Heated Handles Switch
The heated handles switch is located on the right side of the snow thrower handle panel. To activate the heated handles, toggle the switch to the right to generate heat within the handles. Toggle the heated handles switch to the left into the OFF position after using the snow thrower.
NOTE: The heated handles are a compliment to, not a substitute for, proper cold weather outerwear for hands. It is recommended that the user wear adequate winter protection for hands (like gloves/mittens) when operating this snow thrower.
Wheel Steering Controls
The left and right wheel steering controls are located on the underside of the handles and are used to assist in steering the snow thrower. Squeeze the right wheel steering control when turning right, squeeze the left control when turning left. Operate your snow thrower in open areas until you become familiar with these controls. See Figure 7.
NOTE: It is easier to maneuver a
Headlight
The headlight is on whenever the engine is running.
Throttle Control
The throttle control is located on the engine. It regulates the speed of the engine and will shut off the engine when pushed down completely. See Figure 7.
Safety Ignition Key
The safety ignition key must be fully inserted in the switch before the unit will start. Remove the ignition key when the snow thrower is not in use. See Figure 7.
IMPORTANT: Do NOT attempt to turn the key.
SECTION 4: OPERATING YOUR SNOW THROWER
Before Starting | To Start Engine |
WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating.
Gas And Oil Fill-up
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your snow thrower. Read instructions carefully.
WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes an other sources of ignition.
•A plastic cup is provided inside the fuel fill opening on the fuel tank. Remove and discard this cup before filling up the tank. Use the separate fuel tank cap to close after
NOTE: If unit shows any sign of motion (drive or augers) with the clutch grips disengaged, shut engine off immediately. Readjust as instructed in the Final Adjustments in the Assembly Section.
•Attach spark plug wire to spark plug. Make certain the metal loop on end of the spark plug wire (inside the boot) is fastened securely over the metal tip on the spark plug.
•Make certain the auger and drive clutch levers are in the disengaged (released) position.
•Move throttle control up to FAST position. Insert ignition key into slot. See Figure 7. Be certain it snaps into place. Do not turn key.
NOTE: Engine will not start unless ignition key is inserted into ignition slot in carburetor cover.
Electric Starter
•Determine that your house wiring is a
8