Assemble a shoulder bolt, a 3/8" lock washer and a 3/8" hex lock nut to the bottom hole in each side plate. See figure 3.
Proceed to page 8.
J
FIGURE 3 | RIGHT SIDE VIEW |
TRACTORS WITH AXLE MOUNTED FRONT SUSPENSION BRACKETS
•Remove any bolts present in the holes shown in figure 4 on both sides of the tractor frame.
THESE HOLES
MUST BE EMPTY
\\ | \ | \\ |
FRONT
SUSPENSION
BRACKET
\
FIGURE 4 | RIGHT SIDE VIEW |
•Attach the R.H. Side Plate (marked "R") to the right side of the tractor frame as shown in figure 5. For the front hole use a 3/8" x 1" hex bolt, a 3/8" lock washer, and a 1/2" flat washer. Use the flat washer as a shim
between the frame and the side plate. For the rear hole use a 3/8" x 1" hex bolt, and a 3/8" lock washer.
Repeat for the L.H. side.
NOTE: If the bolt inserts freely into the front hole, the
3/8" lock washer along with a 3/8" hex lock nut must be assembled onto the bolt from inside the tractor
frame.
3/8" LOCK | 1/2" FLAT |
WASHER | WASHER |
[]
3/8" x 1"
HEX BOLT
R.H. SIDE
PLATE
FIGURE 5 | RIGHT SIDE VIEW |
•Assemble a shoulder bolt, a 3/8" lock washer and a 3/8" hex lock nut to the bottom hole in each side plate. See figure 6.
3_"HEX LOCK NUT
3/_ LOCK W_SHER
3/8" SHOULDER BOLT
FIGURE 6 | RIGHT SIDE VIEW |
7