OPERATION
MUFFLER
CHOKE CONTROL 
THROTTLE
CONTROL
ON/OFF
SWITCH
|
| AUGER | DRIVE SPEED |
|
| POWER CORD | CONTROL | CONTROL LEVER | DEFLECTOR |
| LEVER | |||
GASOLINE | PLUG |
| REMOTE | |
|
| |||
FILLER CAP |
|
| CONTROL LEVER | |
| ELECTRIC | DISCHARGE |
|
|
| START | CHUTE |
|
|
| BUTTON | CONTROL |
|
|
|
| LEVER |
|
|
PRIMER
SAFETY IGNITION
KEY
FUEL
RECOIL STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
LIGHT 
TOOLBOX
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
DRIFT
CUTTER
AUGERS
SKID PLATE
FIG. 10
LH TURN
TRIGGER
TRACTION DRIVE CONTROL LEVER
HANDLE
KNOB
MUFFLER
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine. ON / OFF switch - used to STOP the engine.
Throttle- used to select FAST or SLOW engine speeds. 9
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
LH and RH turn triggers - used to steer the snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
Drift cutter - used to cut through deep snowdrifts.