OPERATION
MUFFLER
GASOLINE
FILLER CAP
CHOKE
CON-
TROL
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
PRIMER
FUEL
RECOIL (AUXILIARY) STARTER HANDLE
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
AUGERS
ELECTRIC AUGER
START CONTROL
BUTTON LEVER
POWER
CORD
PLUG
CHUTE
DEFLECTOR
DISCHARGE
CHUTE
FIG. 8
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | TRACTION | |
CONTROL LEVER | ||
DRIVE | ||
| ||
| CONTROL | |
| LEVER |
LIGHT
CHUTE
DEFLECTOR
KNOB
HANDLE
KNOB
MUFFLER
TOOLBOX
SKID PLATE
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for starting the engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage power- propelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
8